Ford Galaxy / Ford S-MAX. Manual — part 864
Anti-Theft - Passive - Key and Remote
Transmitter Programming Using
Diagnostic Equipment
S-MAX/Galaxy 2006.5 (02/2006-)
General Procedures
General Equipment
NOTE: This procedure requires access to the Global Secure Vehicle Information System
(GSEVIN) database in order to obtain the coded security access.
NOTE: This procedure will not erase programmed ignition keys from the passive anti-theft
system (PATS).
NOTE: A maximum of 8 ignition keys can be programmed to a vehicle equipped with a
passive anti-theft system (PATS).
Ford diagnostic equipment
1. From the diagnostic tool menu Select:
Body/Security/PATS Functions. Follow the
instructions on the screen.
General Equipment:
Ford diagnostic equipment
2. From the diagnostic tool menu Select: Ignition
Key Programming. Follow the instructions on the
screen.
Anti-Theft - Passive - Spare Key
Programming
S-MAX/Galaxy 2006.5 (02/2006-)
General Procedures
1. A maximum of eight keyless entry remote
transmitters can be programmed to the central
junction box (CJB). Programming must be carried
out at the same time for all the remote
transmitters.
2. To enter programming mode, first make sure
that the vehicle battery is fully charged and that
the anti-theft system is not armed or triggered.
3. Make sure that the turn signal lamp switch is in
the OFF position.
4. Fasten the safety belts and close all doors to
make sure that conflicting chimes do not sound
during programming.
5. The ignition switch must be turned to position II
exactly four times during remote transmitter
programming. Failure to follow this instruction
may result in incorrect remote transmitter
programming.
6. Turn the ignition switch from position 0 to
position II four times exactly within six seconds.
7. Turn the ignition switch to position I.
8. Press and hold one of the buttons on the remote
transmitter.
9. After each successful programming, another 10
second learning mode is automatically entered,
up to a maximum of seven times.
10. To program additional remote transmitters,
repeat step 9.
11. The system will leave the learning mode after the
ignition switch is turned to either position II or
III, or if no new remote transmitter is
programmed during the 10 seconds, or if eight
remote transmitters have been programmed.
12. An incorrect programming procedure does not
affect the stored codes.
13. After successful programming, only the new
programmed remote transmitters will be
accepted.
14. Test all the programmed remote transmitters, by
activating and deactivating the locking/unlocking
functions.
Anti-Theft - Passive - Passive Anti-Theft
System (PATS) Transceiver
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: This procedure will not erase programmed ignition keys from the passive anti-theft
system (PATS).
Installation
1.
2.
3.
1. To install, reverse the removal procedure.
Multifunction Electronic Modules - Module
Controlled Functions
S-MAX/Galaxy 2006.5 (02/2006-)
Description and Operation
Overview
Description
HS CAN bus
MS CAN bus
Gateway (GEM)
GEM
Front/rear window wiper motors
Headlamp
Item
1
2
3
4
5
6
Part Number
-
-
-
-
-
-
-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст