Ford Galaxy / Ford S-MAX. Manual — part 796
Exterior Lighting - Headlamp Switch
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
Installation
1.
1. Install the components in reverse order.
Exterior Lighting - Headlamp Leveling
Front Sensor
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
1. Raise the vehicle.
Refer to:
Lifting
(100-02 Jacking and Lifting,
Description and Operation).
2.
1. Torque: 8 Nm
2. Torque: 10 Nm
1. To install, reverse the removal procedure.
2. Following installation of the front headlamp
leveling sensor, calibrate the headlamp leveling
system using WDS.
3. Check the aim of the dip beam headlamps.
Refer to:
Headlamp Adjustment
(417-01 Exterior
Lighting, General Procedures).
Exterior Lighting - Headlamp Leveling
Rear Sensor
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
1. Raise the vehicle.
Refer to:
Lifting
(100-02 Jacking and Lifting,
Description and Operation).
2. Torque: 10 Nm
1. To install, reverse the removal procedure.
2. Following installation of the rear headlamp
leveling sensor, calibrate the headlamp leveling
system using WDS.
3. Check the aim of the dip beam headlamps.
Refer to:
Headlamp Adjustment
(417-01 Exterior
Lighting, General Procedures).
Interior Lighting - Interior Lighting
S-MAX/Galaxy 2006.5 (02/2006-)
Diagnosis and Testing
Refer to Wiring Diagrams Section 417-02, for schematic and connector
information.
General Equipment
Inspection and Verification
1. 1. Verify the customer concern.
2. 2. Visually inspect for obvious signs of electrical damage.
Visual Inspection Chart
3. 3. If an obvious cause for an observed or reported concern is found, correct the cause
(if possible) before proceeding to the next step.
4. 4. If the cause is not visually evident, verify the symptom and refer to the Symptom
Chart.
Symptom Chart
Worldwide Diagnostic System (WDS)
Electrical
Bulb(s)
Fuse(s)
Switch(es)
Wiring harness
Electrical connector(s)
Interior lamp(s)
Battery saver relay
Central junction box (CJB)
Symptom
Possible Sources
Action
The front interior lamp is inoperative
Fuse(s).
Bulb(s).
Circuit(s).
Front interior lamp.
Battery saver relay.
CJB.
*
*
*
*
*
*
GO to Pinpoint
Test
A.
*
The middle interior lamp is inoperative
Fuse(s).
Bulb(s).
Circuit(s).
Middle interior lamp.
Battery saver relay.
CJB.
*
*
*
*
*
*
GO to Pinpoint
Test
B.
*
The rear interior lamp is inoperative
Fuse(s).
Bulb(s).
Circuit(s).
Rear interior lamp.
Battery saver relay.
CJB.
*
*
*
*
*
*
GO to Pinpoint
Test
C.
*
The luggage compartment lamp is inoperative
Fuse(s).
Bulb(s).
Circuit(s).
Luggage compartment
*
*
*
*
GO to Pinpoint
Test
D.
*
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст