Ford Galaxy / Ford S-MAX. Manual — part 921
screw.
4. 4. Contact a ground point with the negative lead of the multimeter. The voltage
reading should not change.
5. 5. With the negative lead of the multimeter grounded, touch each grid line of the
heated rear window at its pinpoint with the positive lead. A reading of
approximately six volts indicates that the line is OK. A reading of zero volts
indicates that the line is broken between the midpoint and the battery side of the
grid line. A reading of 12 volts indicates that the circuit is broken between the
midpoint of the grid line and ground.
6. 6. INSTALL a new heated rear window glass.
REFER to: Liftgate Window Glass (501-11 Glass, Frames and Mechanisms, Removal
and Installation).
Glass, Frames and Mechanisms - Door
Window Motor Initialization
S-MAX/Galaxy 2006.5 (02/2006-)
General Procedures
WARNING: The window anti-trap function will not operate during the window motor
initialization procedure.
NOTE: Make sure that the window runs are correctly installed and free of foreign material.
NOTE: If the power to a window regulator motor has been disconnected, that window
regulator motor must be initialized.
NOTE: Wait for a minimum of 1 minute before connecting the battery, fuse or electrical
connector.
1. Start the engine.
2. Press and hold the power window control switch
close button until the door window is fully closed.
3. Release the power window control switch close
button.
4. Press the power window control switch close
button three times for one second.
5. Briefly press the power window control switch
open button to the 2nd detent and release the
button. The door window should open
automatically.
6. Briefly press the power window control switch
close button to the 2nd detent and release the
button. If the door window does not close
automatically, repeat the complete procedure.
7. Repeat the door window motor initialization for
each door window motor.
8. Switch off the engine.
Glass, Frames and Mechanisms - Windshield Glass
S-MAX/Galaxy 2006.5 (02/2006
Removal and Installation
Materials
General Equipment
Removal
All vehicles
Vehicles with heated windshield
Name
Specification
Windscreen Adhesive Kit - 1 Component WSK-M11P57-A3 / 7U7J-T03863-AA
Windshield Adhesive Kit
WSS-M11P57-A5
Adhesive tape
Direct glazing removal/replacement equipment
Knife
1. Refer to:
Window Glass Health and Safety Precautions
General Information, Description and Operation).
2.
1. Material:
Windshield Adhesive Kit (WSS-M11P57
2. Remove the polyurethane (PU) adhesive cap and heat the 2K
PU adhesive for a minimum of 30 minutes.
General Equipment:
Direct glazing removal/replacement
equipment
3. Repairs under warranty:
Material:
Windscreen Adhesive Kit - 1 Component (WSK
M11P57-A3 / 7U7J-T03863-AA)
3. Refer to:
Cowl Panel Grille
(501-02 Front End Body Panels, Removal
and Installation).
4.
5.
Vehicles with manual dimming interior mirror
Vehicles with autolamps and rain sensor
6.
7.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст