Ford Galaxy / Ford S-MAX. Manual — part 66
Rear Disc Brake - Brake Pads—Vehicles
With: Electronic Parking Brake (EPB)
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Materials
Removal
CAUTION: Refer to:
Brake System Health and Safety Precautions
(100-00 General
Information, Description and Operation).
NOTE: Removal steps in this procedure may contain installation details.
Installation
Name
Specification
Brake Fluid - Super DOT4 WSS-M6C57-A2
1. Refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
2. Activate the electronic parking brake caliper
actuator service mode.
Refer to:
Electronic Parking Brake (EPB) Release
Using the Vehicle Systems
(206-05 Parking
Brake and Actuation, General Procedures).
3.
4.
WARNING: Make sure that no load is
placed on the brake hose.
Torque:
35 Nm
5.
NOTE: Note the position of each component
before removal.
1.
CAUTIONS:
Make sure that the mating faces are
clean and free of foreign material.
Make sure that the clips are correctly
located.
Make sure that the component is not
bent.
Remove the adhesive foil from the rear of the
outer brake pad.
2. To install, reverse the removal procedure.
3. Deactivate the electronic parking brake caliper
actuator service mode.
Refer to:
Electronic Parking Brake (EPB) Release
Using the Vehicle Systems
(206-05 Parking
Brake and Actuation, General Procedures).
4. Depress and release the brake pedal 3 times,
check the brake fluid level in the brake fluid
reservoir and top up as necessary with brake
fluid.
Material:
Brake Fluid - Super DOT4 (WSS-
M6C57-A2)
Rear Disc Brake - Brake Caliper
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Materials
General Equipment
Removal
CAUTION: Refer to:
Brake System Health and Safety Precautions
(100-00 General
Information, Description and Operation).
NOTE: Removal steps in this procedure may contain installation details.
Name
Specification
Brake Fluid - Super DOT4 WSS-M6C57-A2
Hose clamp(s)
1. Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
2.
3.
1. General Equipment:
Hose clamp(s)
2. Torque: 18 Nm
3. Torque: 35 Nm
4.
CAUTION: Make sure that all openings
are sealed.
5.
NOTE: Note the position of the brake pads to
aid installation.
Installation
6. Torque: 110 Nm
1.
CAUTIONS:
Make sure that the mating faces are
clean and free of foreign material.
Make sure that the clips are correctly
located.
Make sure that the component is not
bent.
To install, reverse the removal procedure.
2. Depress and release the brake pedal 3 times,
check the brake fluid level in the brake fluid
reservoir and top up as necessary with brake
fluid.
Material:
Brake Fluid - Super DOT4 (WSS-
M6C57-A2)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст