Ford Galaxy / Ford S-MAX. Manual — part 31
Description
Shock absorber and spring assembly
Wheel knuckle
Wheel hub
Heat shield
Lower arm
Stabilizer bar
Front subframe
Vibration damper (if equipped)
Stabilizer bar clamp and bushing assembly
Stabilizer bar link
Shock absorber wiring harness
Item 1 : Shock absorber and spring assembly
Continuous damping control shock absorbers provide dynamic front suspension. A
continuous damping control shock absorber creates a damping force which depends on the
velocity of the vehicle and an electrical current applied to the continuous damping control
shock absorber. The electronic stability program (ESP) sensors, acceleration sensors and
displacement sensors provide information to the dynamic suspension electronic control unit
(ECU), which detects the state of heave, roll, pitch, cornering and acceleration of the
vehicle. The ECU then calculates the best damping characteristics for each wheel within 2
ms. The ECU sends an individual electrical current to each shock absorber to control the
amount of damping required.
Item
1
2
3
4
5
6
7
8
9
10
11
Part Number
-
-
-
-
-
-
-
-
-
-
-
Front Suspension - Front Wheel Bearing
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Special Tool(s)
Removal
NOTE: Removal steps in this procedure may contain installation details.
204-348
Remover/Installer, Wheel Hub/Wheel Bearing
204-348/3
Remover/Installer, Wheel Hub/Wheel Bearing
204-348-01
Adapter for 204-348
205-074
Installer, Differential Bearing Cone
205-332
Protector, Axle Shaft
1. Remove the wheel knuckle.
Refer to:
Wheel Knuckle
(204-01 Front
Suspension, Removal and Installation).
2. Special Tool(s):
204-348
,
205-332
Installation
1.
CAUTION: The smaller diameter of the
tool 205-074 must be upermost. Check the
installation of the wheel bearing. Wheel
bearing must be fully home.
1. Wheel bearing.
Special Tool(s):
204-348
,
204-348-01
,
205-074
,
204-348/3
2. Wheel knuckle.
2. To install, reverse the removal procedure.
Front Suspension - Wheel Knuckle
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Special Tool(s)
Removal
NOTE: Removal steps in this procedure may contain installation details.
Vehicles with high intensity discharge headlamps
Vehicles with dynamic suspension
204-159
Lever, Wheel Knuckle
204-605
Separator, Lower Arm Ball Joint
204-607
Remover, Ball joint
204-609
Protection Cap, Ball Joint Gaiter
1. Loosen the wheel hub bolt.
2. Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
3.
4.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст