Ford Galaxy / Ford S-MAX. Manual — part 956
Vehicles with VIN plate body code: M
9.
10.
11.
12. If equipped
Vehicles with VIN plate body code: S
Installation
Vehicles with VIN plate body code: M
Vehicles with VIN plate body code: S
All vehicles
13. If equipped
1.
NOTE: Cutlines may already exist on the inner
surface of a new bumper cover.
On both sides.
General Equipment:
Round-ended steel rule
General Equipment:
15 mm drill bit
2.
NOTE: Cutlines may already exist on the inner
surface of a new bumper cover.
On both sides.
General Equipment:
Round-ended steel rule
General Equipment:
15 mm drill bit
3.
1. Align the
flattened
side
horizontal
upwards,
before
punching
each
hole.
Special
Tool(s):
501-130
4.
NOTE: Make
sure that the
correct
parking aid
sensor
housing is
used as a
template to
mark the
position of the
location
grooves.
5. General
Equipment:
Flat
file
6. To install, reverse the removal procedure.
Bumpers - Front Bumper Cover—Vehicles
Without: Front Parking Aid
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Vehicles with VIN plate body code: M
1.
2.
3. On both sides.
4. Remove the headlamps.
Refer to:
Headlamp Assembly
(417-01 Exterior
Lighting, Removal and Installation).
5. If equipped
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст