Ford Galaxy / Ford S-MAX. Manual — part 314
minutes of applying the sealant.
Apply a 3 mm bead of sealant to the cylinder head.
Material:
Silicone Sealant LB (WSE-M4G323-A4 / 2U7J
M4G323-AA)
30. Torque:
8 Nm
11 Nm
Stage 1:
Stage 2:
31. When installing the old sensor.
Torque:
4 Nm
32.
When installiung a new sensor.
Install the CMP sensor until the tip of the sensor
touches the back of the camshaft pulley.
Torque:
4 Nm
33. Special Tool(s):
303-684
34. Special Tool(s):
205-072
,
205-072-01
,
303-174
35.
NOTE: The component must be installed within 5
minutes of applying the sealant.
Material:
Silicone Sealant LB (WSE-M4G323-A4 / 2U7J
M4G323-AA)
36. Torque: 9 Nm
37.
NOTE: Use a new seal.
Torque:
20 Nm
Engine - 2.2L Duratorq-TDCi
(129kW/175PS) - DW - Engine
S-MAX/Galaxy 2006.5 (02/2006-)
Installation
Special Tool(s)
General Equipment
303-122
Lifting Bracket, Engine
Hose clamp remover/installer
Hydraulic jib crane
Mounting table set
1. Special Tool(s):
303-122
General Equipment:
Hydraulic jib crane
2. Torque: 48 Nm
3. Torque: 48 Nm
4. Torque: 48 Nm
5. Torque: 48 Nm
6. Refer to:
Starter Motor
(303-06F Starting
System - 2.2L Duratorq-TDCi (129kW/175PS) -
DW, Removal and Installation).
Refer to:
Generator - 2.2L Duratorq-TDCi
(129kW/175PS) - DW
(414-02 Generator and
Regulator, Removal and Installation).
7.
WARNING: Make sure that the engine
and transmission assembly is on wooden
blocks and secured with suitable retaining
straps.
General Equipment:
Mounting table set
8. Lower the vehicle.
9. Loosen: 2 turn(s)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст