Ford Galaxy / Ford S-MAX. Manual — part 165
19. Install the correct valve tappet.
20.
CAUTION: Make sure that the camshafts
and camshaft bearing caps are installed in
their original locations.
Coat the camshaft bearing caps with oil.
Material:
Hypoid Oil 85W-90 (SQ-M2C9002-AA /
A72SX-19K261-CA)
21. Install the camshafts approximately at valve
overlap position cylinder No. 4.
Torque:
7 Nm
16 Nm
Stage 1:
Stage 2:
22.
NOTE: The camshaft sprocket bolt must not
be tightened at this stage.
NOTE: Make sure that the camshaft sprocket
can rotate on the camshaft.
23. Attach the special tool.
Special Tool(s):
303-376B
24.
25. Attach the special tool.
Special Tool(s):
303-748
26.
WARNING: Only rotate the crankshaft
clockwise.
Turn the crankshaft until it stops against the
special tool.
27.
CAUTION: Counterhold the camshaft at
the hexagon with a wrench to prevent the
camshaft from rotating.
Torque:
72 Nm
28.
29. Tighten the M6 x 18 mm bolt finger-tight only.
30.
CAUTION: Make sure that a new bolt is
installed.
Special Tool(s):
205-072
,
205-072-02
Torque:
100 Nm
90°
Stage 1:
Stage 2:
31.
32. Remove the special tool.
Special Tool(s):
303-376B
33. Remove the special tool.
Special Tool(s):
303-748
34.
CAUTION: Only rotate the crankshaft
clockwise.
Rotate the crankshaft one and three quarters
until piston No. 1 is approximately 45 degrees
before top dead center (TDC).
35. Attach the special tool.
Special Tool(s):
303-748
36.
CAUTION: Only rotate the crankshaft
clockwise.
Turn the crankshaft until it stops against the
special tool.
37.
NOTE: The bolt can only be installed if the
valve timing is correct.
Tighten the M6 x 18 mm bolt finger-tight only.
38.
NOTE: The special tool can only be installed if
the valve timing is correct.
Attach the special tool.
Special Tool(s):
303-376B
39. Remove the special tool.
Special Tool(s):
303-376B
40. Remove the special tool.
Special Tool(s):
303-748
41.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст