Ford Galaxy / Ford S-MAX. Manual — part 225
Installation
NOTE: Cover the collet grooves with adhesive tape during installation of the valve stem
seals.
1. Coat the valve stem seals with clean engine oil.
Material:
Engine Oil - 5W-30 (WSS-M2C912-A1)
2. Special Tool(s):
303-037
3. To install, reverse the removal procedure.
Engine - 1.8L Duratorq-TDCi
(74kW/100PS) - Lynx/1.8L Duratorq-
TDCi (92kW/125PS) - Lynx - Camshaft
Seal
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Special Tool(s)
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
303-199A
Installer, Camshaft Seal
303-293
Remover, Crankshaft Seal
1. Remove the timing belt.
Refer to:
Timing Belt
(303-01E Engine - 1.8L
Duratorq-TDCi (74kW/100PS) - Lynx/1.8L
Duratorq-TDCi (92kW/125PS) - Lynx, Removal
and Installation).
2.
3. Special Tool(s):
303-293
1. Special Tool(s):
303-199A
2.
NOTE: Do not fully tighten the camshaft
pulley retaining bolt at this stage.
To install, reverse the removal procedure.
Engine - 1.8L Duratorq-TDCi
(74kW/100PS) - Lynx/1.8L Duratorq-
TDCi (92kW/125PS) - Lynx - Timing Belt
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Special Tool(s)
General Equipment
Removal
205-072
Universal Flange Holding Wrench
303-193
Timing Peg, Crankshaft TDC
303-376B
Alignment Plate, Camshaft
303-393
Locking Tool, Flywheel
303-651
Remover, Camshaft Sprocket
Cable ties
Trolley jack
1. Disconnect the battery.
Refer to:
Battery Disconnect and Connect
(414-
01 Battery, Mounting and Cables, General
Procedures).
2. Refer to:
Valve Cover
(303-01E Engine - 1.8L
Duratorq-TDCi (74kW/100PS) - Lynx/1.8L
Duratorq-TDCi (92kW/125PS) - Lynx, Removal
and Installation).
3.
4.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст