Ford Galaxy / Ford S-MAX. Manual — part 927
Vehicles with VIN plate body code: M
clean and free of foreign material.
Carefully trim the remaining PU adhesive from
the liftgate window glass flange.
General Equipment:
Knife
2. Prepare the liftgate window glass, liftgate
window glass flange and trimmed PU adhesive in
accordance with the instructions supplied with
the PU adhesive kit.
General Equipment:
Hot air gun
Material:
Windshield Adhesive Kit (WSS-M11P57-
A5)
3.
NOTE: Discard the first 100 mm of adhesive
as this may have a reduced working time.
NOTE: Make sure that any breakage in the
continuous bead of adhesive is overlapped
by 20 mm.
Apply the PU adhesive in a continuous bead of
between 8 and 10 mm in height to the liftgate
window glass flange along the bond line.
General Equipment:
Direct glazing
removal/replacement equipment
Material:
Windshield Adhesive Kit (WSS-M11P57-
A5)
4.
NOTE: Make sure that the mating faces are
clean and free of foreign material.
5.
NOTE: Make sure that these components are
installed to the noted removal position.
6. Apply PU adhesive to the liftgate handle.
Vehicles with VIN plate body code: S
All vehicles
General Equipment:
Direct glazing
removal/replacement equipment
Material:
Windshield Adhesive Kit (WSS-M11P57-
A5)
7.
NOTE: This step requires the aid of another
technician.
Press firmly and evenly into position.
General Equipment:
Direct glazing
removal/replacement equipment
Material:
Windshield Adhesive Kit (WSS-
M11P57-A5)
Using tape, secure the liftgate window
glass in the correct position until the PU
adhesive has cured.
8.
NOTE: Make sure that these components are
installed to the noted removal position.
9.
NOTE: This step requires the aid of another
technician.
Press firmly and evenly into position.
General Equipment:
Direct glazing
removal/replacement equipment
Material:
Windshield Adhesive Kit (WSS-
M11P57-A5)
Using tape, secure the liftgate window
glass in the correct position until the PU
adhesive has cured.
10. If the ambient temperature falls below 10°C,
apply warm air (25°C) continuously for 15
minutes.
General Equipment:
Hot air gun
11.
Glass, Frames and Mechanisms - Door
Window Regulator—Vehicles With: Manual
Windows
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
1. Remove the rear door window glass.
Refer to:
Rear Door Window Glass
(501-11
Glass, Frames and Mechanisms, Removal and
Installation).
2.
3.
1. To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст