Ford E-350 (2010 year). Manual — part 22

Quick-release captains chair (7 passenger configuration- second
row only)

To remove the seat:

1. Disengage the lap/shoulder belt
from the seat by inserting a key or
small screwdriver into the slot in the
detachable anchor and lifting
upward.

2. Pull the seat latch handle, then
pull the seat toward the right side of
the vehicle to disengage four pins
from the floor mount.

3. Remove the seat.

To install the seat:

WARNING: Check to see that the seat and seatback is latched
securely in position. Keep floor area free of objects that would

prevent proper seat engagement. Never attempt to adjust the seat
while the vehicle is in motion.

WARNING: Ensure that the seat is latched to the vehicle floor
by pushing/pulling on the seat. If not latched, the seat may cause

injury during a sudden stop.

Seating and Safety Restraints

89

1. Position the seat to the floor
mount.

2. Pull the seat latch handle downward to lock the seat in position.

3. Make sure the safety belt is not twisted, then insert the safety belt
tongue into detachable anchor until you hear a “click” and feel the latch
engage.

Rear bench seat

To remove the seats:

1. Disengage the lap/shoulder belt
from the seat by inserting a key or
small screwdriver into the slot in the
detachable anchor and lifting
upward (2nd row passenger side
only).

Seating and Safety Restraints

90

2. Find the clips attached near the
ends of the lap/shoulder belts.

3. Clip the end of the belt to the
stationary portion of the shoulder
belt coming out of the trim panel.

The end of the shoulder belt must
be clipped in order to keep it from
striking anything during vehicle
operation.

Seating and Safety Restraints

91

4. With assistance, pull the LH/RH seat latch release straps (1) (located
behind the latch mechanisms) to release the latch from the rear strikers.

5. Lift the rear end of seat upward and rearward by pushing on the
seatback (2) and lifting the seat cushion (3) to disengage the front seat
hook and the rear seat latch from the striker.

6. With assistance, remove the seat assembly.
• To remove the 3rd, 4th, and 5th row seats (if equipped), repeat

Steps 1 through 6.

To install the seat:

WARNING: Ensure that the seat is installed or removed from
the striker pins with adequate ergonomic assistance. Due to the

weight of the seat, it must be handled by at least two adults during
installation or removal from the vehicle.

WARNING: Ensure that the seat is latched to the vehicle floor
by pushing/pulling on the seat or seatback (2). If not latched,

the seat may cause injury during a sudden stop.

1. Please make sure the floor striker area is clean of any debris that
would prevent the seat from latching.

2. With assistance, position the seat in the vehicle.

3. Align the front hooks to the LH/RH front striker pins prior to lowering
the rear latch mechanism and aligning them with the rear striker pins.

Seating and Safety Restraints

92