Ford Aspire (1997 year). Manual — part 22
85
Removing slack from the belt
WARNING
Rear-facing child seats or infant carriers
should never be placed in the front seats.
6.
Before placing the child in the child seat,
forcibly tilt the seat from side to side, and
tug it forward to make sure that the seat is
securely held in place. See Figure 7.
86
7.
Double-check that the retractor is in the
automatic locking mode. Try to pull more
belt out of the retractor. If you cannot, the
belt is in the automatic locking mode. See
Figure 8.
Checking that retractor is in automatic locking mode
8.
Check to make sure that the child seat is
properly secured prior to each use. If the
retractor is not locked, repeat steps 4
through 7.
NOTE: To remove the retractor from the
automatic lock mode, unbuckle the belt and
allow the seat belt to retract fully to its stowed
position and the retractor will automatically
switch back to the vehicle sensitive locking
mode for normal adult usage.
87
Attaching Safety Seats With Tether Straps
Some manufacturers make safety seats that
include a tether strap that goes over the back of
the vehicle seat and attaches to an anchoring
point. Other manufacturers offer the tether strap
as an accessory. Contact the manufacturer of
your child safety seat for information about
ordering a tether strap.
Front Seats
To install a tether from a child safety seat in the
front seat:
1.
Buckle the lap/shoulder belt in the right rear
seat.
2.
Pull all the stored belt out of the rear seat
retractor to switch the retractor to automatic
locking mode.
3.
Let the retractor wind up the slack from the
lap/shoulder belt.
4.
Install the child safety seat in the front seat.
Refer to the previous section on
Installing
Safety Seats
. Hook the tether strap hook
around the webbing near the center of the
shoulder portion of the locked lap/shoulder
belt.
5.
Tighten the tether strap.
Rear Seats
If you use a tethered safety seat on one of the
rear seats, you can anchor the strap to the
appropriate tether anchor directly behind that
seat position.
88
Tether Anchorage Hardware
All vehicles built for sale in Canada include a
tether anchor hardware kit for use with
Canadian child safety seats.
Vehicles built for sale in the USA
do not
include
the tether anchor hardware kit, but it can be
obtained at no charge from any Ford or
Lincoln-Mercury dealer.
Your vehicle has two tether attachment locations
in the luggage compartment. To access the tether
attachment locations, you must pry off the caps.
Be sure to follow the child safety seat
manufacturer’s instructions.
WARNING
Tighten the anchor according to
specifications. Otherwise, the safety seat
may not be properly secured and the child
may be injured in a sudden stop or
collision.
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст