Ford Ranger EV (2001 year). Manual — part 59
303-03-14
303-03-14
Engine Cooling
REMOVAL AND INSTALLATION
Coolant Pump
Removal
1. If connected, disconnect the vehicle from the
charging station.
2. Disconnect the auxiliary battery ground cable.
3.
CAUTION: Do not remove the radiator
pressure relief cap if the coolant is hot or if
the coolant pump is running.
Turn the radiator pressure relief cap to the first
stop to remove any remaining pressure.
4. Raise and support the vehicle. Refer to
5. Remove the LH inner fender splash shield.
•
Disconnect the six clips.
6. NOTE: When removing the water pump, it is
preferable to clamp off the coolant lines rather
than letting them drain.
Clamp off and disconnect the coolant lines from
the water pump.
303-03-15
303-03-15
Engine Cooling
REMOVAL AND INSTALLATION (Continued)
7. Disconnect the coolant pump electrical
connector.
8. Remove the coolant pump.
1 Remove the bolt.
2 Remove the pump.
Installation
1. To install, reverse the removal procedure.
•
After installation, bleed the cooling system.
Refer to
Cooling System Drain, Fill and
Coolant Pump —Postal Ranger EV
Removal
1. If connected, disconnect the vehicle from the
charging station.
2. Disconnect the auxiliary battery ground cable.
303-03-16
303-03-16
Engine Cooling
REMOVAL AND INSTALLATION (Continued)
3.
CAUTION: Do not remove the radiator
pressure relief cap if the coolant is hot or if
the coolant pump is running.
Turn the radiator pressure relief cap to the first
stop to remove any remaining pressure.
4. Raise and support the vehicle. Refer to
5. Remove the LH inner fender splash shield.
6. NOTE: When removing the water pump, it is
preferable to clamp off the coolant lines rather
than letting them drain.
Clamp off and disconnect the coolant lines from
the water pump.
303-03-17
303-03-17
Engine Cooling
REMOVAL AND INSTALLATION (Continued)
7. Disconnect the coolant pump electrical
connector.
8. Remove the coolant pump.
1 Remove the bolt.
2 Remove the coolant pump.
Installation
1. To install, reverse the removal procedure.
•
After installation, bleed the cooling system.
Refer to
Cooling System Drain, Fill and
Cooling Fan
Removal
1. Disconnect the auxiliary battery ground cable.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст