Ford Ranger EV (2001 year). Manual — part 27
204-02-13
204-02-13
Rear Suspension
REMOVAL AND INSTALLATION (Continued)
24. NOTE: LH shown, RH similar.
Position the LH and RH ABS wheel speed
sensors and install the bolts.
25. NOTE: LH shown, RH similar.
Position the LH and RH backing plates and
install the bolts.
26. Lower the vehicle.
27. Tighten the spring through bolt.
28. Tighten the spring through bolt.
204-02-14
204-02-14
Rear Suspension
REMOVAL AND INSTALLATION (Continued)
29. Install the LH and RH hubs. Refer to
.
30. Install the RH spring. Refer to
.
Rear Shock Absorber
Removal
1.
Raise and support the vehicle. Refer to
2.
CAUTION: Do not position the jack
stand under the tube portion of the rear axle
or vehicle damage may result.
Support the axle.
•
Position the jack stand under the cast end of
the axle.
3.
Lower the vehicle approximately two inches (5
cm) to remove tension on the shock absorber.
4.
Remove the upper shock absorber nut.
204-02-15
204-02-15
Rear Suspension
REMOVAL AND INSTALLATION (Continued)
5.
Remove the shock absorber.
•
Remove the nut.
Installation
1.
To install, reverse the removal procedure.
204-02-16
204-02-16
Rear Suspension
REMOVAL AND INSTALLATION (Continued)
Spring
Special Tool(s)
Spring Flattening Tools
204-F002
Cap Aligner
204-F003
Removal
NOTE: Both Spring Flattening Tools (204-F002)
must be used to flatten the rear springs.
NOTE: The LH spring procedure is shown, the RH
procedure is similar.
NOTE: The rear lifting points are changed for
spring removal.
1.
Position the hoist LH and RH rear lifting points
as shown.
2.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст