Ford F150 Pickup. Instruction — part 944
Fig. 676: Removing Oil Level Indicator Tube
Courtesy of FORD MOTOR CO.
All Cylinder Heads
41. Clean and inspect the exhaust manifolds. For additional information, refer to ENGINE
SYSTEM - GENERAL INFORMATION .
42. Install the special tools on both ends of the cylinder head.
Fig. 677: Installing Special Tools On Ends Of Cylinder Head
Courtesy of FORD MOTOR CO.
NOTE:
The hydraulic lash adjusters must be reinstalled in their
original locations. Record the hydraulic lash adjuster
2003 Ford Pickup F150
2003 ENGINE Engine - 4.6L & 5.4L - F150 Pickup
Fig. 678: Removing Hydraulic Lash Adjusters
Courtesy of FORD MOTOR CO.
43. Remove the hydraulic lash adjusters.
RH Cylinder Head
locations.
CAUTION: The cylinder head must be cool before removing it from
the engine. Cylinder head warpage can result if a warm or
hot cylinder head is removed.
CAUTION: Place clean shop towels over exposed engine cavities.
Carefully remove the towels so foreign material is not
dropped into the engine.
CAUTION: The cylinder head bolts must be discarded and new bolts
installed. They are tighten-to-yield designed and cannot
be reused.
CAUTION: Do not use metal scrapers, wire brushes, power abrasive
2003 Ford Pickup F150
2003 ENGINE Engine - 4.6L & 5.4L - F150 Pickup
discs or other abrasive means to clean the sealing
surfaces. These tools cause scratches and gouges that
make leak paths. Use a plastic scraping tool to remove all
traces of the head gasket.
CAUTION: Aluminum surfaces are soft and can be scratched easily.
Never place the cylinder head gasket surface,
unprotected, on a bench surface.
2003 Ford Pickup F150
2003 ENGINE Engine - 4.6L & 5.4L - F150 Pickup
Fig. 679: Removing RH Cylinder Head
Courtesy of FORD MOTOR CO.
44. Remove the bolts and the RH cylinder head.
2003 Ford Pickup F150
2003 ENGINE Engine - 4.6L & 5.4L - F150 Pickup
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст