Ford F150 Pickup. Instruction — part 357
2. Disconnect the anti-lock brake control module electrical connector.
Fig. 51: Disconnecting Anti-Lock Brake Control Module Electrical Connector
Courtesy of FORD MOTOR CO.
3. Disconnect the pump motor electrical connector from the anti-lock brake control module.
2003 Ford Pickup F150
2003 BRAKES Anti-Lock Control - 4-Wheel - F150 Pickup
Fig. 52: Disconnecting Pump Motor Electrical Connector
Courtesy of FORD MOTOR CO.
4. Remove the screws and the anti-lock brake control module.
2003 Ford Pickup F150
2003 BRAKES Anti-Lock Control - 4-Wheel - F150 Pickup
Fig. 53: Removing Anti-Lock Brake Control Module Screws
Courtesy of FORD MOTOR CO.
5. To install, reverse the removal procedure.
SENSOR - REAR
Removal & Installation
1. Raise and support vehicle. For additional information, refer to JACKING & HOISTING .
2. Remove the rear anti-lock brake sensor.
1. Disconnect the rear anti-lock brake sensor electrical connector.
2. Remove the bolt.
NOTE:
At the first key-on after a new ABS module is installed, use the NGS with
the service card to configure the module. For additional information, refer
to MODULE CONFIGURATION .
NOTE:
Clean off dirt and debris that may have collected around the rear anti-lock
brake sensor before removal.
2003 Ford Pickup F150
2003 BRAKES Anti-Lock Control - 4-Wheel - F150 Pickup
3. Remove the rear anti-lock brake sensor.
Fig. 54: Removing Rear Anti-Lock Brake Sensor
Courtesy of FORD MOTOR CO.
NOTE:
Thoroughly clean the mounting surface.
NOTE:
Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the
O-ring with SAE-75W-140 High Performance Rear Axle Lubricant F1TZ-
19580-B or equivalent meeting Ford specification WSL-M2C192-A.
2003 Ford Pickup F150
2003 BRAKES Anti-Lock Control - 4-Wheel - F150 Pickup
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст