Ford F150 Pickup. Instruction — part 664
Fig. 47: Pressing Bearing Cup
Courtesy of FORD MOTOR CO.
6. Remove the shaft from the special tool, and install the new snap ring.
2003 Ford Pickup F150
2003 DRIVELINE/AXLES Driveshaft & Universal Joints - F150 Pickup
Fig. 48: Installing Snap Ring
Courtesy of FORD MOTOR CO.
Opposite Bearing Cup Installation
7. Repeat Slip-yoke installation in this procedure to install the new bearing cup and snap ring on the
opposite side of the driveshaft slip-yoke.
Final Assembly
CAUTION: Do not strike the bearings.
2003 Ford Pickup F150
2003 DRIVELINE/AXLES Driveshaft & Universal Joints - F150 Pickup
Fig. 49: Striking Yoke
Courtesy of FORD MOTOR CO.
8. Check the U-joint for freedom of movement.
z
If binding, strike the yoke with a brass or plastic hammer.
DRIVESHAFT UNIVERSAL JOINT - SINGLE CARDAN, FLANGE YOKE
Special Tool(s)
2003 Ford Pickup F150
2003 DRIVELINE/AXLES Driveshaft & Universal Joints - F150 Pickup
Fig. 50: Identifying Special Tool(s)
Courtesy of FORD MOTOR CO.
Disassembly
Initial Disassembly
1. Place the driveshaft on a suitable workbench. Do not damage the tube.
CAUTION: Do not, under any circumstance, clamp the driveshaft in the jaws of a
vise or similar holding fixture. Denting or localizing fracture can
result, causing driveshaft failure during vehicle operation.
NOTE:
If components are not marked and installed incorrectly, driveline
imbalance can occur.
2003 Ford Pickup F150
2003 DRIVELINE/AXLES Driveshaft & Universal Joints - F150 Pickup
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст