Ford F150 Pickup. Instruction — part 321

Fig. 19: Pinpoint Test G: A Chime Is Inoperative - Air Bag (G4 - G5)
Courtesy of FORD MOTOR CO.

GENERAL PROCEDURES

BELT MINDER DEACTIVATING/ACTIVATING

Preparation

1. Before deactivating/activating the belt minder, set the parking brake.

2. Place gearshift in P (Park) (automatic transmission) or the neutral position (instruction transmission)

3. Place the ignition switch in the OFF position

4. Close all the vehicle doors

5. Unbuckle the driver's safety belt

6. Place the parklamps/headlamps switch in the OFF position (If vehicle is equipped with Autolamps, this

will not affect the procedure)

Deactivating/Activating

1. Turn the ignition switch to the RUN position. (Do not start the engine)

2. Wait until the safety belt warning lamp turns off. (Approximately one to two minutes)

3. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled.

This portion of the procedure can be done before or during belt minder warning activation.

4. Turn the parklamps/headlamps on then off.

5. Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the

safety belt warning lamp will be illuminated for three seconds.

NOTE:

Steps 3 through 5 must be completed within 60 seconds or the procedure
must be repeated.

2003 Ford Pickup F150

2003 ACCESSORIES AND EQUIPMENT Warning Devices - F150 Pickup

6. Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt.

This will enable the belt minder if disabled or disable belt minder is enabled.

7. The following sequence of events confirm the belt minder is enabled:

z

flashing of the safety belt warning belt lamp four times per second for three seconds

z

three seconds with the safety belt lamp off

z

flashing the safety belt lamp four times per second for three seconds again

8. The safety belt lamp flashing four times per second for three seconds provides confirmation of belt

minder disabled.

9. After confirmation, the deactivation/activation procedure is complete.

REMOVAL AND INSTALLATION

SWITCH - DOOR OPEN WARNING LAMP

Removal and Installation

Refer to DOOR AJAR SWITCH .

2003 Ford Pickup F150

2003 ACCESSORIES AND EQUIPMENT Warning Devices - F150 Pickup

2003 ACCESSORIES AND EQUIPMENT

Wipers and Washers - F150 Pickup

SPECIFICATIONS

GENERAL SPECIFICATIONS

Fig. 1: General Specifications
Courtesy of FORD MOTOR CO.

TORQUE SPECIFICATIONS

2003 Ford Pickup F150

2003 ACCESSORIES AND EQUIPMENT Wipers and Washers - F150 Pickup

2003 Ford Pickup F150

2003 ACCESSORIES AND EQUIPMENT Wipers and Washers - F150 Pickup

Fig. 2: Torque Specifications
Courtesy of FORD MOTOR CO.

DESCRIPTION AND OPERATION

WIPERS AND WASHERS

The wiper and washer system consists of:

z

RH and LH windshield wiper blades.

z

RH and LH windshield wiper pivot arms.

z

Windshield wiper mounting arm and pivot shaft.

z

Windshield wiper motor.

z

Windshield washer hose.

z

Windshield washer nozzle jet and bracket.

z

Windshield washer reservoir.

DIAGNOSIS AND TESTING

2003 Ford Pickup F150

2003 ACCESSORIES AND EQUIPMENT Wipers and Washers - F150 Pickup