Ford Falcon. Manual — part 134
303-01b-50
Engine — 5.4L (3V)
303-01b-50
IN-VEHICLE REPAIR (Continued)
36. Remove the through bolt from the RH motor
30. Disconnect the crankshaft position (CKP) sensor.
mount
31. Disconnect the A/C compressor electrical
37. Remove the plate bolts and the inspection cover
connector.
38. Remove the four bolts from the torque converter
32. Remove the bolts and the A/C compressor.
and discard (Auto tran only).
NOTE: Do not degas, position A/C compressor
NOTE: Gain access to the nuts by turning the
out of the way.
crank dampener counterclockwise.
33. Remove nut holding exhaust heatshield and
discard, then remove heatshield.
34. Disconnect the pipes at the exhaust manifolds.
NOTE: If studs are removed from exhaust
manifolds during disassembly, then discard studs
and nut and replace with new parts.
35. Remove the through bolt from the LH engine
mount.
G89792 en
303-01b-51
Engine — 5.4L (3V)
303-01b-51
IN-VEHICLE REPAIR (Continued)
39. Remove the 6 bolts from the transmission.
5. Position the transmission level indicator tube and
install the bolt.
40. Lower the vehicle.
6. Install the five bolts to the bell housing.
41. Install rear lifting hook and front lifting hook.
42. Support the transmission with a floor jack and a
block of wood.
43. Remove the engine from the vehicle.
7. Install the oil filter.
Installation
1. Support the transmission with a floor jack and a
block of wood.
2. Install the engine in the vehicle.
3. Remove the special tool.
4. Raise the vehicle. For additional information, refer
to Section 100-02.
G89792 en
303-01b-52
Engine — 5.4L (3V)
303-01b-52
IN-VEHICLE REPAIR (Continued)
8. Install 4 new bolts to the torque converter (Auto
11. Install the bolt to the RH engine motor mount.
trans only).
NOTE: Gain access to the nuts by turning the
crank dampener counterclockwise.
12. Install the bolt to the LH engine motor mount.
9. Install the plug (Auto trans only).
13. Install the starter motor and 2 bolts.
10. Install the inspection cover and the bolts.
G89792 en
303-01b-53
Engine — 5.4L (3V)
303-01b-53
IN-VEHICLE REPAIR (Continued)
20. Install the A/C compressor and bolts.
14. Connect the cable and install the motor nut.
21. Connect the A/C compressor electrical connector.
15. Connect the starter motor electrical connectors.
Position the starter solenoid wire.
Position the battery cable.
Install the nuts.
22. Connect the crankshaft position sensor.
16. Install the starter motor solenoid terminal cover.
17. Install the RH exhaust manifold studs.
18. Connect the exhaust pipes to the exhaust
manifolds and torque nuts to specification.
19. Install the heatshield and fasten with a new
heatshield nut.
G89792 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст