Ford Probe (1997 year). Manual — part 15
65
Manual headlamp retractors located behind the headlamps
High Beams and Flashing the Lamps
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
To turn off the high beams, pull the lever
toward you until it latches. The high beam
indicator light turns off.
66
Flashing the Lights
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
Highbeam and flash-to-pass operation
If the headlamps are retracted when you pull
the lever toward you, they will pop up and
flash.
67
Turn Signals
Move the lever up to signal a right turn. Move
it down to signal a left turn. The corresponding
indicator light in the instrument cluster will
flash.
If the turn signal stays on after you turn, move
the lever back to the center (OFF) position.
For lane changes, move the lever far enough to
signal but not to latch. The lever will return to
the off position when you release it.
Turn signal
68
Windshield Wipers and Washer
To operate the windshield wipers and washers,
make sure your ignition key is turned to the ON
position.
The windshield wipers have two speeds. To
operate the wipers, pull down the lever on the
right side of your steering column. The first
position is LO (Low) and the second position is
HI (High). To turn the wipers off, return the
lever to the uppermost position.
Windshield wiper control
ONE-TOUCH WIPER CONTROL (If equipped)
— For one wiping cycle, push the lever away
from you and release it with the lever in the
OFF or interval position. The ignition switch
must be in the ON position for this operation.
One touch wiper control
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст