Ford E-150 (2012 year). Manual — part 72

The transmission fluid should be in this range if at ambient temperature
(50°F-95°F [10°C-35°C]).

High fluid level

Fluid levels above the safe range may result in transmission failure.

An overfill condition of transmission fluid may cause shift and/or
engagement concerns and/or possible damage.

High fluid levels can be caused by an overheating condition.

H

C

ADD

COLD

HOT

DO NOT ADD

H

C

ADD

COLD

HOT

DO NOT ADD

Maintenance and Specifications

289

Adjusting automatic transmission fluid levels

Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick. Refer to Maintenance
product specifications and capacities in this chapter.

Use of a non-approved automatic transmission fluid may cause
internal transmission component damage.

If necessary, add fluid in 1/2 pint (250 ml) increments through the filler
tube until the level is correct.

If an overfill occurs, excess fluid should be removed by an authorized
dealer.

An overfill condition of transmission fluid may cause shift and/or
engagement concerns and/or possible damage.

Do not use supplemental transmission fluid additives, treatments or
cleaning agents. The use of these materials may affect transmission
operation and result in damage to internal transmission components.

H

C

ADD

COLD

HOT

DO NOT ADD

Maintenance and Specifications

290

Automatic transmission fluid filter

The TorqShift

威 automatic

transmission is equipped with a
serviceable transmission fluid filter
located inside the transmission
bottom pan.

Refer to scheduled maintenance
information for service intervals for
automatic transmission fluid and
transmission filter.

For transmission filter maintenance,
see your authorized dealer.

AIR FILTER

Refer to scheduled maintenance information for the appropriate
intervals for changing the air filter element.

When changing the air filter element, use only the air filter element
listed. Refer to Motorcraft

威 part numbers in this chapter.

WARNING: To reduce the risk of vehicle damage and/or
personal burn injuries do not start your engine with the air

cleaner removed and do not remove it while the engine is running.

Maintenance and Specifications

291

Changing the air filter element

1. Disconnect the fresh air inlet tube
from the radiator support.

2. Open the clamp that secures the
two halves of the air filter housing
together.

3. Carefully separate the two halves
of the air filter housing.

4. Remove the air filter element
from the housing.

5. Install a new air filter element. Be careful not to crimp the filter
element edges between the air filter housing. This could cause filter
damage and allow unfiltered air to enter the engine if not properly
seated.

6. Replace the two halves of the air filter housing and secure the clamp.

7. Connect the fresh air inlet tube to the radiator support.

Note: Failure to use the correct air filter element may result in severe
engine damage. The customer warranty may be void for any damage to
the engine if the correct air filter element is not used.

VEHICLE STORAGE

If you plan on storing your vehicle for an extended period of time
(30 days or more), refer to the following maintenance recommendations
to ensure your vehicle stays in good operating condition.

All motor vehicles and their components were engineered and tested for
reliable, regular driving. Long term storage under various conditions may
lead to component degradation or failure unless specific precautions are
taken to preserve the components.

Maintenance and Specifications

292