Ford Aerostar (1997 year). Manual — part 17
65
Standard Heater
The control for your heater system is located
near the center of the instrument panel and
operates only when the ignition key is turned to
the ON position. The heater heats and/or
ventilates your vehicle interior depending on the
function and temperature you select. The right
knob is the SELECT knob which allows you to
select heating or ventilation and determine
where the air will be directed. The TEMP knob
setting determines the temperature of the air
that flows into the vehicle.
Climate control knobs (heater only)
66
To turn the heater system on, rotate the SELECT
knob to any position except OFF. This turns on
the fan and allows airflow into the vehicle.
Temperature selection
The TEMP knob is the rotating knob located at
the center of the control with tapered red and
blue bands surrounding most of the knob. The
wide red part of the band (full right) is the heat
area. The wide blue area (full left) is the cool
area. Any position selected between full right
and full left will give a temperature between the
two extremes. The cool temperature you select
will not be cooler than the outside temperature.
Fan speed adjustment
The left knob or upper left knob with the
x
is
the fan speed knob. Rotate the
x
knob to the
right to increase fan speed and increase the
amount of air entering the vehicle. Four fan
speed positions are available.
Function selection
Use VENT to bring outside air through the
instrument panel registers. You can heat the air
in this position by rotating the TEMP knob into
the red area. The air cannot be cooled below the
outside temperature regardless of the TEMP
knob setting.
Airflow will be to the floor when FLR is
selected. The air can be heated by rotating the
temperature knob into the red area.
Select MIX to get air to the floor and windshield
defrosters at the same time.
Select
V
to obtain maximum airflow to the
windshield. Rotate the TEMP knob into the red
area for the air temperature required to defrost.
Rotate the
x
knob to increase or decrease the
airflow.
67
Operating Tips
The following tips will help you to get the most
satisfaction from your heater system.
❑
In humid weather, select
V
before starting
your engine. This will help to prevent
windshield fogging. After a few minutes, you
may select another airflow position.
❑
To prevent humidity buildup inside your
vehicle, always drive with the heater system
turned on.
❑
Do not put objects under the front seats that
interfere with the flow of air to the back seat
area.
❑
Remove any snow, ice, or leaves from the air
intake area at the bottom of the windshield.
❑
For maximum heating, rotate the function
selector knob to FLR, the temperature control
knob to the red (warm) range, and the fan
blower knob to HI.
Auxiliary Heater and Air
Conditioner (If equipped)
If your vehicle is equipped with a factory
installed auxiliary unit (heater or heater/air
conditioner), the front control assembly will
include separate switches for FRONT and REAR
fan control. Fan speed for front and rear systems
can be set as desired by adjusting these switches.
68
Front control assembly with rear blower knob
In addition, an auxiliary unit fan switch is
located on the left side of the vehicle in line
with the second row of seats.
To control the auxiliary unit fan speed with this
switch, the rear fan switch on the front control
must first be set at the REAR CONT (control)
position.
Rear mounted auxiliary fan switch
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст