Ford Aerostar (1997 year). Manual — part 36
142
R
WARNING
Failure to follow all of the instructions on
the use of this child restraint system can
result in your child striking the vehicle’s
interior during a sudden stop or crash.
How to use the Built-In Child Seat
Read the following procedures and all of the
labels on the Built-In Child Seat before using the
seat.
R
WARNING
Never use the Built-In Child Seat as a
booster cushion with the adult safety
belts. A child using the adult belts could
slide forward and out from under the
safety belts.
1.
Pull the headrest release strap and grasp the
headrest as shown in Figure 1. Then release
the strap and rotate the headrest fully until
the latch “clicks” in the full up position.
Figure 1
2.
Continue to unfold the child seat until it
rests on the seat as shown in Figure 2.
143
Figure 2
3.
Read the information and warnings on the
child seat. Check the child’s size, weight and
age to be sure the child is not too small or
too large for the child seat. Refer to Figure 3.
144
Figure 3
4.
Pull up on the two black looped straps at
the upper corners of the child seat to unsnap
the cushion protector flap.
5.
Lower the seat cushion.
6.
Pull the lap and shoulder belts cinch release
strap while pulling the shoulder belts fully
out. Refer to Figures 4 and 5.
145
Figure 4
Figure 5
6.
If connected, squeeze the top and the bottom
of the right half of the chest clip and pull to
separate both halves.
7.
Place the child on the child seat and position
the shoulder belts over each shoulder. Refer
to Figure 6.
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст