Ford Aerostar (1997 year). Manual — part 20
77
To clean the windshield, push in the end of the
wiper knob. For a constant spray, keep the knob
pushed in. After you release the knob, the
wipers operate for two to three cycles before
turning off (if wipers were off) or returning to
the selected setting.
NOTE:
The addition of bug shields to the
front of the vehicle (e.g., shields) may
adversely affect the windshield washer
system from delivering fluid to the
windshield. Devices such as shields are
not recommended for your Ford
vehicle.
Do not try to clean the windshield when the
washer fluid container is empty or activate the
washers at any time for more than 15 seconds
continuously. This could damage the washer
pump system.
R
WARNING
Always warm up the windshield with the
defroster before you use the washer fluid.
In freezing weather, the washer solution
may freeze on the windshield and obscure
your vision.
For information about refilling the washer fluid
or replacing your windshield wiper blades, see
Windshield washer fluid and Wipers
in the Index.
Gearshift Lever
The gearshift lever on your Aerostar is mounted
on the steering column. On the end of the
gearshift lever is the OVERDRIVE OFF button.
For additional information about the gearshift
lever and the OVERDRIVE OFF button, see the
Driving
chapter.
78
Overdrive off button
OVERDRIVE OFF Light on Gearshift
Lever
This light indicates the operating range of the
transmission. The word OFF illuminates on the
lever when the OVERDRIVE OFF button is
depressed.
Hazard Flasher Switch
The hazard flasher switch is located on the top
of the steering column. For more information,
refer to
Hazard Flasher
in the
Roadside Emergencies
chapter.
Hazard flasher
79
Tilt Steering (If equipped)
R
WARNING
Never adjust the steering wheel when the
vehicle is moving.
Turn signal and tilt steering release lever
To change the position of the steering wheel,
pull the release lever on the column toward you.
Tip the steering wheel to the desired position.
Release the lever to lock the steering wheel in
place.
Be sure the steering wheel locks in a notch. It is
not infinitely adjustable. Do not adjust the
steering wheel while the vehicle is in motion.
80
Speed Control (If equipped)
Speed control switches on the steering wheel
To Turn Speed Control Off
Press OFF
OR
Turn off the vehicle ignition.
Once speed control is switched off, the
previously programmed set speed will be erased.
To Turn Speed Control On
Press ON
To Set A Speed
Press the SET ACCEL. For speed control to
operate, the speed control must be ON and the
vehicle speed must be greater than 30 mph
(km/h).
If you drive up or down a steep hill, your
vehicle speed may vary momentarily slower or
faster than the set speed.
Speed control cannot reduce the vehicle speed if
it increases above the set speed on a downhill. If
your vehicle speed is faster than the set speed
while driving on a downhill in
j
(Overdrive),
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст