Ford Aerostar (1997 year). Manual — part 30
118
Safety Belt Maintenance
Check the safety belt systems periodically to
make sure that they work properly and are not
damaged.
R
WARNING
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if equipped), shoulder belt height
adjusters (if equipped), child safety seat tether
bracket assemblies (if equipped), and attaching
hardware, should be inspected after any
collision. Ford recommends that all safety belt
assemblies used in vehicles involved in a
collision be replaced. However, if the collision
was minor and a qualified technician finds that
the belts do not show damage and continue to
operate properly, they do not need to be
replaced. Safety belt assemblies not in use
during a collision should also be inspected and
replaced if either damage or improper operation
is noted.
How to Untwist or Unjam a Safety Belt
Retractor
If you should jam the lap belt retractor by
allowing the belt to retract when it is twisted,
you can free the webbing with this procedure:
1.
Pull on the belt with both hands to tighten it
on the retractor spool.
2.
Feed the belt back into the retractor until it
is completely retracted. Repeat previous step
if necessary.
119
3.
Pull the belt out of its holder as far as it will
go and untwist the belt or remove the object
that is jamming the belt. Let the belt retract.
4.
Then, pull the belt out and let it retract
several times to make sure that the belt
works properly.
For Twisted Rear Outboard Combination
Lap and Shoulder Safety Belts —
Detachable Anchor
Disengage the detachable anchor tongue from
the detachable anchor, remove the twist and
re-install the detachable anchor tongue end into
the detachable anchor until you hear a snap and
feel the latch engage.
Procedure to Correct a Twisted Safety Belt
at the “D” Ring (if so equipped) Front
and/or Rear Outboard Seating Positions
NOTE:
The restraint system shown in the
following figures may be different than
the restraint system in your vehicle.
However, use these figures and this
procedure to correct a twisted safety
belt at any outboard seating position
that has a “D” ring.
120
1.
Grasp the belt webbing at the “D” ring. See
Figure 2.
121
2.
Rotate and fold the belt webbing over itself
as required to remove the twist.
3.
Feed the folded portion of the belt through
the “D” ring.
4.
When completed, the safety belt should look
like Figure 3.
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст