Ford Police Interceptor Utility (2018 year). Manual — part 35

Steering Tips

If the steering wanders or pulls, check for:
•

Correct tire pressures.

•

Uneven tire wear.

•

Loose or worn suspension
components.

•

Loose or worn steering components.

•

Improper vehicle alignment.

Note: A high crown in the road or high
crosswinds may also make the steering
seem to wander or pull.

Adaptive Learning

The electronic power steering system
adaptive learning helps correct road
irregularities and improves overall handling
and steering feel. It communicates with
the brake system to help operate
advanced stability control and accident
avoidance systems. Additionally, whenever
the battery is disconnected or a new
battery installed, you must drive your
vehicle a short distance before the system
relearns the strategy and reactivates all
systems.

REAR LOADSPACE HATCHES

(If Equipped)

E203068

Use the key to lock and unlock the door.
Turn the handle to open it.

REAR UNDER FLOOR
STORAGE

Load Safe Label

Refer to the label on the trunk lid or liftgate
for additional information about the spare
wheel and tire.

Load Floor

Do not permanently remove the foam
structure under the load floor that
surrounds the spare tire. It is necessary to
properly support the load floor.

The maximum load floor cargo weight,
evenly distributed and with a full size spare
tire installed, is 800 lb (362 kg).

ROOF RACKS AND LOAD
CARRIERS

(If Equipped)

WARNING

When loading the roof racks, we
recommend you evenly distribute the
load, as well as maintain a low

center of gravity. Loaded vehicles, with
higher centers of gravity, may handle
differently than unloaded vehicles. Take
extra precautions, such as slower speeds
and increased stopping distance, when
driving a heavily loaded vehicle.

The maximum recommended load, evenly
distributed on the crossbars, is:
•

100 lb (45 kg) for vehicles without a
moonroof.

•

45 lb (20 kg) for vehicles with a
moonroof.

For correct roof rack system function, you
must place loads directly on crossbars
affixed to the roof rack side rails. When
using the roof rack system, we recommend
you use Ford Genuine Accessory crossbars
designed specifically for your vehicle.

Make sure that you securely fasten the
load. Check the tightness of the load
before driving and at each fuel stop.

Thumbwheel Kit

E203659

A thumbwheel kit is included in your
vehicle for tying light loads to your roof.
The kit is located in the glovebox.

Make sure to check that the thumbwheels
are tight each time you add or remove load
from the roof rack, and periodically while
traveling. Make sure that the load is secure
before traveling.

Note: There may be snap caps in the side
rail, which must be removed before
installing the thumbwheels. These caps can
be removed by using a T25 torx tool or a
similar tool.

Adjusting the Crossbar

(If Equipped)

Note: For less wind noise and better
aerodynamics, only install the crossbars
when you need them for carrying cargo.
Follow the steps to reposition or remove the
rear crossbar. You can remove the front
crossbar fasteners by unscrewing the
assembly.

E203063

1.

Remove the crossbar bolts at both
sides of the front crossbar by using a
T25 torx tool or a similar tool.

2. Remove the crossbar by sliding the

ends off of the side rails.

3. Move the crossbar to the new side rail

position and slide onto rail.

4. Replace and tighten the bolts at both

sides of the crossbar by using a T25
torx tool or a similar tool.

Note: There may be snap caps in the new
side rail position, which must be removed
before installing the crossbar. You can
remove these caps by using a T25 torx tool
or a similar tool.

LOAD LIMIT

Vehicle Loading - with and
without a Trailer

This section guides you in the
proper loading of your vehicle,
trailer, or both. Keep your loaded
vehicle weight within its design
rating capability, with or without
a trailer. Properly loading your
vehicle provides maximum return
of vehicle design performance.
Before you load your vehicle,
become familiar with the
following terms for determining
your vehicle’s weight rating, with
or without a trailer, from the
vehicle’s Tire and Loading
Information label or Safety
Compliance Certification label.

Tire and Loading Label Information
Example:

E198719

Payload

E143816

PAYLOAD