Ford Mustang (2018 year). Manual — part 18

E142451

Switch the lighting control to the
autolamps position. See Autolamps
(page 72).

Overriding the System

When you switch on the high beams,
pushing or pulling the stalk provides a
temporary override to low beam.

Automatic High Beam Indicator

(If

Equipped)

The indicator lamp illuminates
to confirm when the system is
ready to assist.

FRONT FOG LAMPS

(If Equipped)

E142453

Press the control to switch the fog lamps
on or off.

You can switch the fog lamps on when the
lighting control is in any position except
Off and the high beams are not on.

DIRECTION INDICATORS

E162681

Push the lever up or down to use the
direction indicators.

Note: Tap the lever up or down to make the
direction indicators flash three times to
indicate a lane change.

WELCOME LIGHTING

(If Equipped)

Pony Projection Lights

The pony projection lights are on the
bottom of the exterior mirror housings.
They project an image onto the ground a
short distance from your vehicle when
welcome lighting or lighted entry turns on.

Note: Moisture, frost and ice build-up or
other types of contamination on the surface
of the light lens can cause non-permanent
distortion or reduced brightness of the
image. Do not use abrasive materials to
clean the lens.

Note: For vehicles with manual
transmission, you may need to engage the
parking brake for this feature to operate.

INTERIOR LAMPS

The lamps turn on under the following
conditions:
•

You open any door.

•

You press a remote control button.

•

You press a map lamp button.

Map Lamps

E175199

Left-hand side map lamp.

A

Right-hand side map lamp.

B

Press the button to switch the lamps on
or off.

AMBIENT LIGHTING

Adjust the ambient lighting in the
information display. See General
Information (page 88).

POWER WINDOWS

WARNINGS

Do not leave children unattended in
your vehicle and do not let them play
with the power windows. Failure to

follow this instruction could result in
personal injury.

When closing the power windows,
verify they are free of obstruction and
make sure that children and pets are

not in the proximity of the window
openings.

E180087

Note: You may hear a pulsing noise when
just one of the windows is open. Lower the
opposite window slightly to reduce this
noise.

Note: Use the singular control (if equipped)
to open both rear windows.

Press the control to open the window.

Lift the control to close the window.

One-Touch Down

Press the switch fully and release it. Press
again or lift it to stop the window.

One-Touch Up

Lift the switch fully and release it. Press
again or lift it to stop the window.

Bounce-Back

The window will automatically stop and
reverse some distance if it detects an
obstacle while closing.

Overriding the Bounce-Back Feature

WARNING

When you override the bounce-back
feature the window will not reverse
if it detects an obstacle. Take care

when closing the windows to avoid
personal injury or damage to your vehicle.

Pull up the window switch and hold within
two seconds of the window reaching the
bounce-back position. The window will
travel up with no bounce-back protection.
The window will stop if you release the
switch before the window is fully closed.

Accessory Delay

The window switches remain operational
for several minutes when you switch the
ignition off or until you open either front
door.

GLOBAL OPENING

(If Equipped)

You can use the remote control to open
the windows with the ignition off.

Note: You can enable or disable this feature
in the information display, or see an
authorized dealer. See General
Information (page 88).

Note: To operate this feature, accessory
delay must not be active.

Opening the Windows

You can open the windows for a short time
after you unlock your vehicle with the
remote control. After you unlock your
vehicle, press and hold the remote control
unlock button to open the windows.
Release the button once movement starts.
Press the lock or unlock button to stop
movement.

EXTERIOR MIRRORS

Power Exterior Mirrors

WARNING

Do not adjust the mirrors when your
vehicle is moving. This could result
in the loss of control of your vehicle,

serious personal injury or death.

E176804

Left-hand mirror

A

Adjustment control

B

Right-hand mirror

C

To adjust a mirror:

1.

Select the mirror you want to adjust.
The control will illuminate.

2. Adjust the position of the mirror.

3. Press the mirror switch again.

Fold-Away Exterior Mirrors

Push the mirror toward the door window
glass. Make sure that you fully engage the
mirror in its support when returning it to its
original position.

Heated Exterior Mirrors

(If Equipped)

See Heated Windows and Mirrors (page
113).

Memory Mirrors

(If Equipped)

You can save and recall the mirror
positions through the memory function.
See Power Seats (page 117).

Signal Indicator Mirrors

(If Equipped)

The outer portion of the appropriate mirror
housing will blink when you switch on the
turn signal.

Pony Projection Lights

(If Equipped)

The lights are on the bottom of the mirror
housings. See Welcome Lighting (page
75).

Integrated Blind Spot Mirrors

(If

Equipped)

WARNING

Objects in the mirror are closer than
they appear.

Blind spot mirrors have an integrated
convex mirror built into the upper outboard
corner of the exterior mirrors. They can
increase your visibility along the side of
your vehicle.