Chery B14. Manual — part 32
Unplug related electrical connector (Refer to disassembly/assembly of instrument panel)
2.3 Loose fixing bolts on high/low pressure pipe by
spanner.
2.4 Loose the fixing bolt between high/low pressure pipe
and expansion valve, pull high/low pressure pipe outward.
2.5 Disassemble evaporator water tank inlet and outlet pipe
clip and take off water pipe.
Note: coolant will flow out from the water pipe, pay attention
to recycling the coolant.
2.6 Disassemble interior trim such as driver’s side pedal,
front seats, sub instrument panel, threshold pressing plate etc.
and take off the front end of carpet.
2.7 Disassemble AC cable grounding bolt.
2.8 Loose 5 fixing bolts of evaporator assembly on metal
sheet from front cab, positions see right figure.
Installation torque is 3.5±0.5 Nm
2.9 Take out evaporator and AC cable assembly from cab
3 Installation of evaporator assembly
The installing steps are reverse to those for removal.
4 Disassembly/assembly of interior evaporator
Tool: cross head screwdriver, 4.0 hexagon wrench, socket spanner.
4.1 Blower replacement
4.1.1 Disassembly steps
4.1.1.1 Disassemble blower motor plug and motor speeder
module plug.
4.1.1.2 Disassemble 3 blower motor screws and take out
blower.
4.1.2 Assembly steps
The installing steps are reverse to those for removal.
5 Disassembly/assembly of blower speeder
module
5.1 Disassembly steps
5.1.1 Unplug speeder module plug
Plug of blower motor
Plug of speeder module
Blower motor plug
Speeder module plug
5.1.2 Disassemble 2 speeder module fixing bolts
5.1.3 Take off speeder module
5.2 Assembly steps
The installing steps are reverse to those for removal.
6 Disassembly/assembly of heating water tank
6.1 Disassembly steps
6.1.1 Disassemble evaporator assembly (see disassembly of
evaporator)
6.1.2 Disassemble AC cable (see disassembly of AC cable)
6.1.3 Disassemble evaporator water temperature sensor
6.1.4 Disassemble 2 socket head cap bolt from expansion
valve
Tool: 4.0 allen wrench
6.1.5 Take off expansion valve, tear down gasket around
expansion installation position.
6.1.6 Disassemble mode ventilator connection rod
6.1.7 Disassemble cooling/heating control ventilator
pull rod
6.1.8 Disassemble 14 bolts on evaporator housing,
decomposing evaporator housing.
Note: the sponge seal around housing is one time using
6.1.9 Disassemble 4 bolts on heating cover plate
assembly
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст