Chery Tiggo 5 (T21). Manual — part 500
47–
16
47
Hood Hinge Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front windshield lower garnish left cover plate.
a. Using a screwdriver wrapped with protective tape, pry
up the claws on front windshield lower garnish left
cover plate.
b. Remove the front windshield lower garnish left cover
plate.
4. Remove the hood left hinge assembly.
a. Remove 2 fixing bolts (arrow) between hood hinge
assembly and hood assembly.
(Tightening torque: 23 ± 2 N·m)
WARNING
When removing hood hinge assembly, an assistant is needed to hold hood. Prevent hood from dropping
or sudden closing to cause accidents during operation.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing hood hinge assembly.
When removing hood hinge assembly, prevent hood from dropping to damage body or front windshield
during operation.
RT21480490
RT21470130
47–
17
47
b. Remove the fixing bolt (arrow) between hood hinge
assembly and front fender assembly.
(Tightening torque: 10 ± 1 N·m)
c. Remove 2 fixing bolts (arrow) between hood hinge
assembly and body.
(Tightening torque: 23 ± 2 N·m)
d. Remove the hood hinge Assembly.
Installation
Installation is in the reverse order of removal.
RT21480250
RT21470150
WARNING
When installing hood hinge assembly, an assistant is needed to hold hood. Prevent hood from dropping
or sudden closing to cause accidents during operation.
CAUTION
After installing hood hinge assembly, it is necessary to adjust hood.
When installing hood hinge assembly, prevent hood from dropping to damage body or front windshield
during operation.
47–
18
47
Hood Cable Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the radiator grille assembly (
4. Remove the water tank upper crossmember trim board (
5. Remove the water tank upper crossmember deflector.
a. Remove 2 plastic clips (arrow) and the fixing nut (1)
from the water tank upper crossmember deflector.
(Tightening torque: 10 ± 1 N·m)
b. Remove the water tank upper crossmember deflector.
6. Remove the hood lock assembly.
a. Remove 2 fixing nuts (arrow) from the hood lock
assembly.
(Tightening torque: 10 ± 1 N·m)
b. Disengage the hood cable assembly (arrow) from the
slot.
c. Remove the hood lock assembly.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing hood cable assembly.
Try to prevent body paint surface from being scratched when removing hood cable assembly.
1
RT21370050
RT21370060
RT21370061
47–
19
47
7. Remove the hood grip assembly.
a. Remove 2 fixing crews (arrow) from the hood grip
assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
b. Disengage the hood grip assembly in the direction of
arrow as shown in the illustration.
c. Disengage the hood cable (arrow) to separate it from
the hood grip assembly.
8. Remove the hood cable assembly.
a. Disengage the hood cable assembly from the clips.
b. Remove the hood cable assembly.
RT21470160
RT21470170
RT21470171
RT21470180
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст