Chery Tiggo 5 (T21). Manual — part 472
43–
68
43
5. Mix the adhesive.
a. Using solvent, thoroughly clean the mixing board and scraper.
b. Using a scraper, thoroughly mix 500 g main adhesive
and 75 g hardener on the mixing board.
6. Apply the adhesive.
a. Cut off the tip of cartridge nozzle and add adhesive.
b. Install the cartridge to sealer gun.
c. Apply adhesive evenly to the triangular window glass
assembly as shown in the illustration.
Adhesive width: 8 - 10 mm
Adhesive height: 11 - 13 mm
7. Install the triangular window glass assembly.
a. Align the matchmarks on glass and vehicle body, and
gently press in glass along the rim.
CAUTION
Adhesive should be mixed thoroughly within 5 minutes.
RT21430380
11-13 mm
8-10 mm
RT21430390
CAUTION
Check that lower/upper clearance and right/left clearance of triangular window glass assembly are
uniform.
RT21430400
43–
69
43
b. Uniformly apply adhesive to the glass rim with a
scraper.
c. Remove any excessive or spilled adhesive with a
scraper.
d. Apply tape around the triangular window glass, and remove them when the adhesive becomes hard.
8. Install the triangular window glass trim board.
9. Check and repair the sealing of glass.
a. Check the glass for leakage after adhesive has completely hardened.
b. If it leaks, seal the leaks by adding adhesive.
10.Install the C-pillar upper protector assembly.
11.Connect the negative battery cable.
Adhesive
RT21430410
43–
70
43
Front Windshield Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the roof assembly (
).
HINT:
It is not necessary to completely remove the roof assembly. Lower the front part of roof assembly so that
the front windshield assembly can be removed.
4. Remove the inside rear view mirror assembly (
5. Remove the wiper arm assembly (
).
6. Remove the front windshield lower garnish assembly (
7. Remove the front windshield weatherstrip.
8. Remove the front windshield assembly
a. Cut the adhesive with a knife.
b. Apply protective tape to the outer surface of body to prevent scratches.
c. Pass a piano wire through the seam between body and front windshield assembly.
d. Tie wooden blocks or similar objects to both piano
wire ends, cut off adhesive by pulling the piano wire
around front windshield assembly, and remove the
front windshield assembly.
Cut
RT21430300
CAUTION
Try to prevent body paint surface from being scratched when cutting the adhesive.
CAUTION
To prevent the instrument panel assembly from being scratched, place a plastic sheet between piano
wire and instrument panel assembly.
RT21430420
43–
71
43
9. Clean the vehicle body.
a. Using a knife, cut away excess adhesive on the
contact surface of vehicle body as shown in the
illustration.
CAUTION
When removing front windshield assembly, 2 technicians are required.
DO NOT drop the front windshield assembly when removing it.
Leave as much adhesive on body as possible when cutting the adhesive.
When separating the front windshield assembly from vehicle, be careful not to damage the body paint or
interior/exterior ornaments.
Adhesive
RT21430320
CAUTION
Try to prevent body paint surface from being scratched when cutting the adhesive.
Leave as much adhesive on body as possible when cutting the adhesive.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст