Chery Tiggo 5 (T21). Manual — part 425
37–
39
37
ON-VEHICLE SERVICE
Engine Hood Lock Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the radiator grille assembly (
4. Remove the water tank upper crossmember trim board (
5. Remove the tank upper crossmember deflector.
a. Remove 2 plastic clips (arrow) and the fixing nut (1)
from tank upper crossmember deflector.
(Tightening torque: 10 ± 1 N·m)
b. Remove the tank upper crossmember deflector.
6. Remove the engine hood lock assembly.
a. Remove 2 fixing nuts (arrow) from engine hood lock
assembly.
(Tightening torque: 10 ± 1 N·m)
b. Detach the engine hood cable assembly (arrow) from
clamping part, and remove the engine hood lock
assembly.
CAUTION
Be sure to the wear safety equipment to prevent accidents when removing engine hood lock assembly.
Try to prevent body paint surface from being scratched when removing engine hood lock assembly.
1
RT21370050
RT21370060
RT21370061
37–
41
37
Front Door Lock Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front left door protector assembly (
4. Remove the front left door assist grip mounting bracket assembly (
).
5. Remove the front left door protective film assembly (
).
6. Remove the front left door glass rear guide rail assembly (
).
7. Remove the front left door lock assembly.
a. Disconnect the connector (arrow) from front door lock
assembly.
b. Detach the clip (arrow) connecting front door lock
assembly and front door key cylinder lever.
CAUTION
Be sure to the wear safety equipment to prevent accidents when removing front door lock assembly.
Try to prevent interior and body paint from being scratched when removing front door lock assembly.
RT21370070
RT21370080
37–
42
37
c. Detach the cable (arrow) connecting front door lock
assembly and front door assist grip base.
d. Remove 3 fixing screws (arrow) from front door lock
assembly, and remove the front door lock assembly.
(Tightening torque: 5.8 ± 0.7 N·m)
Inspection
1. Check front door lock assembly (fastener assembly).
a. Apply battery voltage to terminals of front door lock assembly (fastener assembly) connector and check
if front door lock assembly works properly according to the table below.
Front Left Door Lock Assembly
RT21370090
RT21370100
RT21370110
-
+
1 2 3 4 5 6
Measurement Condition
Specified
Condition
Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2
Lock
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 3
Unlock
37–
43
37
Front Right Door Lock Assembly
If result is not as specified, replace front door lock
assembly.
Installation
Installation is in the reverse order of removal.
Measurement Condition
Specified
Condition
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 5
Lock
Battery positive (+) → Terminal 5
Battery negative (-) → Terminal 4
Unlock
CAUTION
Check if connector is installed correctly when installing front door lock assembly.
Install clip and cable on the lever in place when installing front door lock assembly.
Check if front door lock operates properly after installing front door lock assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст