Chery Tiggo 5 (T21). Manual — part 141
10–
10
10
ON-VEHICLE SERVICE
Engine Trim Cover Assembly & Bracket
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine trim cover assembly.
a. Loosen the worm clamp (arrow) and disconnect the
connection between rear intake hose and hot wire air
flow meter.
(Tightening torque: 5 ± 0.5 N·m)
b. Loosen the worm clamp (arrow) and disconnect the
connection between front intake hose and engine trim
cover assembly.
(Tightening torque: 5 ± 0.5 N·m)
c. Remove the engine trim cover assembly from the
bracket.
CAUTION
Be sure to wear necessary safety equipment when repairing to prevent accidents.
Try to prevent body paint surface from being scratched during removal and installation.
RT21100020
RT21100030
RT21100040
10–
11
10
4. Remove the rear intake hose.
a. Loosen the worm clamp (arrow) and remove the rear
intake hose from the engine trim cover assembly.
(Tightening torque: 5 ± 0.5 N·m)
5. Remove the trim cover front bracket.
a. Remove the trim cover front bracket fixing bolt
(arrow), and remove the trim cover front bracket.
(Tightening torque: 7 ± 1 N·m)
6. Remove the trim cover rear right bracket.
a. Remove the exhaust manifold heat insulator.
b. Remove 2 fixing bolts (arrow) from the trim cover rear
right bracket, and remove the trim cover rear right
bracket.
(Tightening torque: 7 ± 1 N·m)
CAUTION
Cover front intake hose with a plastic bag after removing engine trim cover assembly to prevent foreign
matter entering front intake hose.
RT21100050
RT21100060
RT21100070
10–
12
10
7. Remove the trim cover rear left bracket.
a. Remove 2 fixing bolts (arrow) from the trim cover rear
left bracket, and remove the trim cover rear left
bracket.
(Tightening torque: 7 ± 1 N·m)
Installation
Installation is in the reverse order of removal.
RT21100080
10–
13
10
Hot Wire Air Flow Meter
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine trim cover assembly (
).
4. Remove the hot wire air flow meter.
a. Disconnect the hot wire air flow meter connector (1).
b. Remove 2 fixing bolts (arrow) from the hot wire air
flow meter.
(Tightening torque: 4.5 ± 0.5 N·m)
c. Remove the hot wire air flow meter.
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear necessary safety equipment when repairing to prevent accidents.
Try to prevent body paint surface from being scratched during removal and installation.
1
RT21100081
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст