Chery Tiggo 5 (T21). Manual — part 449
40–
7
40
Reversing Radar System (Page 3 of 3)
ET21400030
REAR LEFT
RADAR
SENSOR
RW
WG
RB
B
B
B
B
B
LEFT
CENTER
RADAR
SENSOR
7
1
2
8
15
16
1
2
RIGHT
CENTER
RADAR
SENSOR
1
2
GW
B
REAR RIGHT
RADAR
SENSOR
4
1
2
1
9 10 11 12 13 14 15 16
2
3
4
5
6
7
8
W
B-020
REVERSE
RADAR
MODULE
B-020
2
1
2
1
2
1
2
1
B
B-023
B
B-027
B
B-030
B
B-033
B-023
B-027
B-030
B-025
B-033
40–
8
40
Reversing Radar Control Module Assembly Terminal List
Pin No.
Terminal Definition
Pin No.
Terminal Definition
1
Reversing Signal
9
-
2
-
10
-
3
Ignition Signal
11
-
4
Center Right Reversing Radar
Sensor Signal
12
-
5
-
13
Data Signal (to Body Control Module
(BCM))
6
-
14
-
7
Left Reversing Radar Sensor Signal
15
Right Reversing Radar Sensor
Signal
8
Center Left Reversing Radar Sensor
Signal
16
Ground
40–
9
40
DIAGNOSIS & TESTING
Problem Symptoms Table
HINT:
Use the table below to help determine the cause of problem symptoms. Check each suspected area in
sequence. Repair or replace the faulty components, or adjust as necessary.
Self-checking Function
Reversing radar system has malfunction self-checking function, and the function instructions are as follows:
If reversing radar sensor wire harness and connector are damaged or there is a malfunction in the reversing
radar sensor body, the instrument cluster will alarm after turning ignition switch ON and shifting the shift lever
to R.
Specific alarms are as follows:
1. When system is normal, the buzzer does not sound, and reversing radar system enters normal operation
mode.
2. When there are malfunctions in one or more sensors, relevant reversing radar sensor malfunction will be
displayed on multi-information display, other sensors can also enter normal operation mode.
Symptom
Suspected Area
See page
Reversing radar system does not function
(buzzer in instrument cluster does not
sound)
Back-up light switch Assembly
Reversing radar sensor
-
Camera
-
Reversing radar control module assembly
-
Instrument cluster
Wire harness and connector
-
40–
10
40
ON-VEHICLE SERVICE
Reversing Radar Sensor
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear bumper assembly (
).
HINT:
The reversing radar sensor connector (arrow) has been
disconnected when removing the rear bumper assembly.
4. Remove the reversing radar sensor.
a. Press the claws on reversing radar sensor.
b. Remove the reversing radar sensor from the rear
bumper assembly.
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when removing the reversing radar
sensor.
Operate carefully to avoid damaging the reversing radar sensor when removing the reversing radar
sensor.
RT21400060
RT21480422
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст