Chery Tiggo 5 (T21). Manual — part 440
38–
41
38
Self-diagnosis Detection Logic
Diagnosis Procedure
a. Use X-431 3G diagnostic tester (the latest software) to clear the DTCs stored in the instrument cluster
control system.
b. Turn ignition switch to LOCK and wait for a few seconds.
c. Turn ignition switch to ON.
d. Use X-431 3G diagnostic tester (the latest software) to read the DTCs in the instrument cluster control
system again.
e. Read the DTCs.
DTC
U1300-55 Software Configuration Error, Not Configured
DTC Code
DTC Definition
DTC Detection
Condition
Possible Cause
U1300-55
Software Configuration
Error, Not Configured
Ignition switch ON
Instrument cluster
CAUTION
When performing circuit diagnosis and test, always refer to circuit diagram for specific circuit and
component information.
1
Reconfirm DTCs
Result
Proceed to
DTC U1300-55 is output
NG
No DTC is output
OK
Replace instrument cluster
NG
System is normal
OK
38–
42
38
ON-VEHICLE SERVICE
Instrument Cluster
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Lower the steering wheel in the direction of arrow as
shown in the illustration.
4. Remove the combination switch cover (
).
5. Remove the instrument cluster.
a. Remove 2 fixing screws (arrow) from instrument
cluster.
(Tightening torque: 1.5 ± 0.5 N·m)
b. Using a screwdriver wrapped with protective tape, pry
up the clips on instrument cluster.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing instrument cluster.
Operate carefully to prevent components from being damaged when removing instrument cluster.
DO NOT scratch interior and body paint when removing instrument cluster.
RT21380040
RT21380020
RT21380021
38–
43
38
c. Disconnect the instrument cluster connector (arrow),
and remove the instrument cluster.
Installation
Installation is in the reverse order of removal.
RT21380030
CAUTION
When installing instrument cluster, be sure to align instrument cluster positioning hole with instrument
panel dowel pin, and clips are clamped in place.
When installing instrument cluster, be sure to install connector in place.
When installing instrument cluster, be sure to tighten fixing screws in place.
Operate carefully to prevent other components from being damaged when installing instrument cluster.
38–
44
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст