Chery Tiggo. Manual — part 50
2. Remove the A/C compressor belt.
3. Loosen the generator adjustment bolts (1).
4. Remove the generator belt.
5. Installation is in the reverse order of removal.
Air Cleaner Element
Removal & Installation
1. Loosen the air cleaner case side clamps (1) and
raise the air cleaner case (upper).
2. Remove the air cleaner element.
3. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
LTSM050004
LTSM020239
Air Cleaner Housing
Removal & Installation
1. Disconnect the negative battery cable.
2. Disconnect the air flow sensor electrical connector.
3. Loosen the clamp between the air intake hose and the air cleaner.
4. Remove the retaining bolt (1), securing the air
cleaner housing to its base.
(Tighten: Air cleaner housing retaining bolts to
10 N·m)
5. Remove the air cleaner housing.
6. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
LTSM020240
LTSM020160
02
Cylinder Head Cover
Removal & Installation
1. Disconnect the negative battery cable.
2. Remove the accelerator cable bracket bolts (1).
(Tighten: Accelerator cable bracket bolts to 10 N·m)
3. Remove the accelerator cable.
4. Remove the air flow hose clamp (2) and discon-
nect the air flow hose.
5. Remove the spark plug wires (3) and set them
aside (See Spark Plug Wire Removal & Installation
in Section 03 Electronic Engine Controls).
6. Remove the PCV tube (5).
7. Remove the cylinder head cover bolts (4).
(Tighten: Cylinder head cover bolts to 11 N·m)
8. Remove the cylinder head cover from the cylinder head.
9. Remove the cylinder head cover gasket if necessary.
10. Installation is in the reverse order of removal.
NOTE :
Install a new cylinder head cover gasket during installation.
ON-VEHICLE SERVICE
LTSM020175
Camshaft
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• MD-998719 - Camshaft Belt Gear Holder
• MD-990767 - Camshaft Belt Gear Holder
• MD-998443 - Hydraulic Post Keeper
1 - Rocker Shaft Retaining Bolt
2 - Intake Rocker Arm Shaft
3 - Rocker Arm
4 - Rocker Arm
5 - Rocker Shaft Spring
6 - Hydraulic Adjuster
7 - Rocker Arm and Rocker Shaft
8 - Exhaust Rocker Arm Shaft
9 - Rocker Arm
10 - Rocker Arm and Rocker Shaft
11 - Camshaft Oil Seal
12 - O-Ring
13 - Camshaft Thrust Plate
14 - Camshaft
ON-VEHICLE SERVICE
LTSM020081
02
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст