Chery Tiggo. Manual — part 14
7. Remove the cylinder head bolts in the order
shown.
8. Remove cylinder head gasket.
9. Installation is in the reverse order of removal.
Installation Notes:
• Ensure cylinder head bolt holes in the block are clean, dry (free of residual oil or coolant), and threads are not
damaged.
• The cylinder head bolts should not be reused. The new bolts should be examined before use. If the bolts are
stretched, the bolts should be replaced.
• Position the new cylinder head gasket on the engine block with the part number facing up. Ensure gasket is
seated over the locating dowels in the block.
• Before installing the bolts, the threads should be lightly coated with engine oil.
ON-VEHICLE SERVICE
BESM020065
02
• Install the cylinder head bolts in the order shown.
• Torque the cylinder head bolts in the following three
step sequence:
− 1st Step: Tighten the bolt to 40 ± 5 N·m
− 2nd Step: Tighten the bolt an additional 90 ±
5°
− 3rd Step: Tighten the bolt an additional 90 ±
5°
Front Crankshaft Oil Seal
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• CH-20007 - Front Crankshaft Seal Installer
• CH-20008 - Front Crankshaft Seal Guide
• CH-20019 - Crankshaft Belt Pulley Fixture
1. Remove the accessory drive belt (See Accessory Drive Belt Removal & Installation in Section 02 Engine).
2. Remove the crankshaft vibration damper bolts (1).
(Tighten: Crankshaft vibration damper bolts to
25 N·m)
3. Remove the engine timing belt (See Engine Timing Belt Removal & Installation in Section 02 Engine).
ON-VEHICLE SERVICE
LTSM020236
BESM020055
02
4. Remove the crankshaft timing belt pulley bolt (2)
from the crankshaft.
(Tighten: Crankshaft timing belt pulley bolt to
130 N·m and an additional 65°)
5. Remove the key-way from the crankshaft.
6. Use an appropriate tool and remove the front
crankshaft oil seal (1).
CAUTION:
Be careful not to damage the front cover seal
surface while removing the seal.
7. Installation is in the reverse order of removal.
Installation Notes:
• Lubricate the new front seal with engine oil prior to assembly.
• Use the front crankshaft seal installer CH-20008 (1), to install the new seal.
ON-VEHICLE SERVICE
LTSM020199
LTSM020216
Rear Crankshaft Oil Seal
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• CH-20005 - Rear Crankshaft Oil Seal Installer
• CH-20006 - Rear Crankshaft Oil Seal Guide
• CH-20043 - Flywheel Fixture
1. Remove the transaxle assembly (See Transaxle Assembly Removal & Installation in Section 08 Transaxle &
Transfer Case).
2. Using special tool CH-20043 (1), hold the flywheel.
3. Remove the clutch pressure plate retaining bolts
(1) and then remove the clutch pressure plate.
(Tighten: Clutch pressure plate bolts to 25 N·m)
4. Remove the flywheel bolts (1) and then remove the
flywheel.
(Tighten: Flywheel bolts to 75 N·m)
ON-VEHICLE SERVICE
LTSM080145
BESM080046
BESM020058
02
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст