Chery Tiggo. Manual — part 375
ON-VEHICLE SERVICE
Manual Temperature Control Module
Removal & Installation
1. Disconnect the negative battery cable.
2. Remove the bezel of the central control panel.
3. Remove the bolts, and remove the CD player, and then disconnect the harness connectors.
4. Remove the mounting screws (1).
5. Disconnect the electrical connector behind the panel.
LTSM130013
13
6. Loosen the two blend door and mode door control
cables (1).
7. Remove the manual temperature control module.
8. Installation is in the reverse order of removal.
Blower Motor Resistor
Removal & Installation
WARNING!
The blower motor resistor may get very hot during normal operation. If the blower motor was turned on prior to
servicing the blower motor resistor, wait five minutes to allow the blower motor resistors to cool before per-
forming diagnosis or service. Failure to take this precaution can result in possible personal injury.
CAUTION:
DON
ⴕT operate the blower motor with the blower motor resistor removed from the circuit. Failure to
take this precaution can result in vehicle damage.
1. Disconnect the negative battery cable.
2. Remove the glove box (See Instrument Panel Removal & Installation in Section 15 Body & Accessories).
3. Disconnect the blower motor resistor electrical connector.
ON-VEHICLE SERVICE
LTSM130001
4. Remove the two bolts (1) attaching the blower
motor resistor to the evaporator housing.
5. Remove the blower motor resistor.
6. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
LTSM130002
13
SYSTEM CONTROLS
GENERAL INFORMATION
13-19
Description
13-19
Operation
13-21
Specifications
13-23
Special Tools
13-23
ON-VEHICLE SERVICE
13-24
Recirculation Door Actuator
13-24
Removal & Installation
13-24
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст