Chery Tiggo. Manual — part 208
Engine Cranks Normal But Will Not Start
The following conditions apply to this symptom:
• The engine cranks at normal speed.
• The engine will not start.
• The battery is fully charged.
1.
PRELIMINARY CHECKS
CAUTION:
Extended cranking because of a No Start can load the exhaust system with raw fuel, damaging the
catalytic converter after the engine starts.
• Carry out the following preliminary checks:
− Fuel quality
− Electrical connections
− Intake air tube integrity
− Fuses and relays
Is the check result normal?
Yes
>>
Go to the next step.
No
>>
Repair as necessary.
Verify the symptom no longer exists.
2.
CHECK DTC
• Turn the ignition switch on.
• With the scan tool X-431, select view DTC.
Are there any DTCs present?
Yes
>>
See the Diagnostic Trouble Code (DTC) List.
Go to the specific diagnostic test to troubleshoot the DTC.
No
>>
Go to the next step.
3.
TRY TO START THE ENGINE WITH THE THROTTLE CLOSED
• Attempt to start the engine.
Does the engine start now with the throttle closed?
Yes
>>
Verify the symptom no longer exists.
No
>>
Go to the next step.
4.
CHECK EXHAUST SYSTEM
• Inspect the vehicles exhaust system for restriction.
Is there a restriction in the exhaust system?
Yes
>>
Repair as necessary.
No
>>
Go to the next step.
ELECTRONIC ENGINE CONTROLS - 2.4L ENGINE SYMPTOM DIAGNOSIS
03
5.
CHECK ENGINE CYLINDER COMPRESSION
• Perform a compression test on the engine.
Is engine compression correct?
Yes
>>
Verify test results. If OK, see Diagnostic Test List to repair any additional symptoms.
No
>>
Check for cause.
ELECTRONIC ENGINE CONTROLS - 2.4L ENGINE SYMPTOM DIAGNOSIS
Engine Will Not Crank
The following conditions apply to this symptom:
• The engine will not crank.
1.
PRELIMINARY CHECKS
• Carry out the following preliminary vehicle inspection:
− Fuel quality
− Battery connections
− Starter relay connections
− Manual transmission clutch fully depressed
− Engine immobilizer activated
− Fuses/Fuse links
Is the check result normal?
Yes
>>
Go to the next step.
No
>>
Repair as necessary.
Verify the symptom no longer exists.
•
2.
LISTEN FOR STARTER RELAY CLICKING
• Attempt to start the engine.
Is a clicking sound heard from the starter relay when the ignition key is turned to START?
Yes
>>
Go to the next step.
No
>>
Go to step 5.
3.
CHECK STARTING SYSTEM
• Check the starter, starter ground, starter relay cable to starter and battery.
Is a fault indicated?
Yes
>>
Repair as necessary.
No
>>
Go to the next step.
4.
CHECK OPERATION OF OTHER ELECTRICAL ACCESSORIES
• Check all accessories.
Do any other electrical accessories work?
Yes
>>
Go to the next step.
No
>>
Check the charging system.
ELECTRONIC ENGINE CONTROLS - 2.4L ENGINE SYMPTOM DIAGNOSIS
03
5.
CHECK DTC
• Turn the ignition switch on.
• With the scan tool X-431, read the DTC.
Are there any DTCs present?
Yes
>>
Check for cause.
No
>>
Go to the next step.
6.
CHECK STARTING SYSTEM PRIMARY CIRCUITS
• Check the starting system primary circuits as follows:
− Starter relay
− Ignition switch
Are components/systems OK?
Yes
>>
Ensure customer’s concern has been resolved.
No
>>
Repair as necessary.
ELECTRONIC ENGINE CONTROLS - 2.4L ENGINE SYMPTOM DIAGNOSIS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст