Chery Tiggo. Manual — part 344
STEERING GEAR
GENERAL INFORMATION
11-19
Description
11-19
Operation
11-19
Specifications
11-19
Special Tool
11-19
DIAGNOSIS & TESTING
11-20
Binding and Sticking Troubleshooting
Chart
11-20
Insufficient Assist / Poor Return To Center
Troubleshooting Chart
11-20
ON-VEHICLE SERVICE
11-21
Steering Gear - LHD
11-21
Removal & Installation
11-21
Steering Gear - RHD
11-25
Removal & Installation
11-25
Tie Rod
11-29
Removal & Installation
11-29
Inspection
11-30
GENERAL INFORMATION
Description
The steering gear used is the rack-and-pinion type with power assist. It is mounted on the front suspension sub-
frame. The outer ends of the outer tie rods attach to the front knuckles.
NOTE :
The power steering gear should not be serviced or adjusted. If a malfunction or steering fluid leak occurs with the
steering gear, the complete steering gear needs to be replaced.
Operation
The steering wheel turns the pinion. The rack is a long flat bar with geared teeth on one side. The rack teeth mesh
with the teeth on the pinion gear. Rotation of the pinion moves the rack from left to right and right to left. The tie rod
then causes the wheels to turn to the left or right.
Specifications
Torque Specifications
DESCRIPTION
TORQUE (N·m)
Inlet / Outlet Pipe Nut
25 - 30
Intermediate Shaft Bolt
25 - 30
Steering Gear to Sub-Frame Bolts
70 - 80
Sub-Frame Assembly Bolts
180 ± 15
Tie Rod End Nut
32 - 38
Tie Rod Jam Nut
15
Wheel Mounting Nuts
110
Special Tool
Ball Joint Separator
CH-10002
11
DIAGNOSIS & TESTING
Binding and Sticking Troubleshooting Chart
CONDITION
POSSIBLE CAUSES
CORRECTION
Difficult To Turn Wheel Sticks Or
Binds
· Low fluid level.
· Tire pressure.
· Steering component.
· Loose belt.
· Low pump pressure.
· Column shaft coupler binding.
· Steering gear worn or out of
adjustment.
· Ball joints binding.
· Belt routing.
· Fill to proper level.
· Adjust tire pressure.
· Inspect and lubricate.
· Adjust or replace.
· Pressure test and replace if
necessary.
· Replace coupler.
· Repair or replace gear.
· Inspect and repair if necessary.
· Verify belt routing is correct.
Insufficient Assist / Poor Return To Center Troubleshooting Chart
CONDITION
POSSIBLE CAUSES
CORRECTION
Hard Turning Or Momentary
Increase In Turning Effort
· Tire pressure.
· Low fluid level.
· Loose belt.
· Lack of lubrication.
· Low pump pressure or flow.
· Internal gear leak.
· Belt routing.
· Adjust tire pressure.
· Fill to proper level.
· Adjust or replace.
· Inspect and lubricate steering and
suspension components.
· Pressure and flow test and repair if
necessary.
· Pressure and flow test, and repair
if necessary.
· Verify belt routing is correct.
Steering Wheel Does Not Want To
Return To Center Position
· Tire pressure.
· Wheel alignment.
· Lack of lubrication.
· High friction in steering gear.
· Ball joints binding.
· Adjust tire pressure.
· Align front wheels.
· Inspect and lubricate steering and
suspension components.
· Test and adjust if necessary.
· Inspect and repair if necessary.
ON-VEHICLE SERVICE
Steering Gear - LHD
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• CH-10002 - Ball Joint Separator
1. Siphon out as much power steering fluid as possible from the reservoir.
WARNING!
Prolonged and repeated contact with power steering fluid will damage skin. If steering fluid is spilled on your
skin, wash it off immediately with water.
2. Remove the wheel mounting nuts and wheel assemblies from both sides of the vehicle.
(Tighten: Wheel mounting nuts to 110 N·m)
3. Remove the return hose clamp (1) from the steer-
ing liquid reservoir and insert the end of the hose
into a container.
4. Start the engine and turn the steering wheel from lock-to-lock until all power steering fluid has been drained from
the system.
5. Stop the engine.
6. Raise and support the vehicle.
1 - Steering Gear Inlet/Outlet Pipe
2 - Dust Boot
3 - Steering Gear Lock Nut
4 - Steering Gear Retaining Hole
5 - Clamp
6 - Tie Rod Lock Nut
LTSM110036
LTSM110042
11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст