Chery Tiggo. Manual — part 324
Torque Specifications
DESCRIPTION
TORQUE (N·m)
Bow Beam to Plate Bolts
60 ± 5
Front Intermediate Shaft to ITM Controller Bolts
70 ± 7
ITM Bracket to Bow Beam Bolts
60 ± 5
ITM Control Module Bolts
9 ± 1
Transaxle to Transfer Case Bolts
80
Rear Intermediate Shaft to ITM Controller Bolts
39 ± 3
Rear Intermediate Shaft to Rear Differential Bolts
65 ± 6
Transfer Case Fluid-Limiting Bolt
40 ± 3
Transfer Case Fluid Fill Bolt
40 ± 3
Transfer Case Fluid Drain Bolt
40 ± 3
Transfer Case Front Housing Bolt
35
Transfer Case Rear Housing Bolts
40
Transfer Case Right Bearing Seat Bolt
35
Transfer Case Vent Bolt
18 ± 3
Fluid Specifications
NAME
TYPE
QUANTITY
MAINTENANCE TERM
Transaxle Gear Fluid
GL-4 75w-90
2.2 Liters
1 year / 30,000 km
Transfer Case Gear Fluid
GL-5 80w-90
0.8 Liters
50,000 km
Rear Final Drive Gear
Fluid
Hypoid 85w-90
0.8 Liters
50,000 km
Transfer Case Specifications
Differential Assembly
Side Gear
Type of Gear
Straight bevel gear
Number of Gears
14
Planetary Gear
Type of Gear
Straight bevel gear
Number of Gears
10
Hypoid G Gear
Drive Gear
Number of Gears
41
Driven Gear
Number of Gears
14
ITM Control Module Electronic Signals
SIGNALS
MODE OF PROVISION
SIGNAL SOURCE
Signals Of The Four Wheel Speed
CAN
Wheel Speed Sensor
Vehicle Speed Signals
CAN
Vehicle Speed Sensor
Acceleration Signals
CAN
G Sensor
Engine Speed Signals
CAN
Crankshaft Position Sensor
Throttle Position Signals
CAN
Throttle Position Sensor
Steering Wheel Angle Signals
Simulated
ITM Module
Ignition Switch Signals
Direct
Ignition Switch
GENERAL INFORMATION
09
Special Tools
Diagnostic Scan Tool
X-431
Digital Multimeter
Fluke 15B & 17B
GENERAL INFORMATION
ON-VEHICLE SERVICE
Interactive Torque Management (ITM) Controller
Description
The ITM Controller is mounted between the front and rear intermediate drive shafts.
NOTE :
Under normal vehicle usage, the ITM Controller requires no maintenance
Operation
The ITM Controller transfers the torque output from the transaxle to the rear drive axle.
LTSM160008
LTSM160005T
09
Removal & Installation
1. Raise and support the vehicle.
2. Remove the front intermediate drive shaft (See Front Intermediate Drive Shaft Removal & Installation in Section
09 Driveline & Axle).
3. Remove the rear intermediate drive shaft (See Rear Intermediate Drive Shaft Removal & Installation in Section
09 Driveline & Axle).
4. Remove the ITM Controller electrical connector (1).
5. Remove the ITM Controller mounting bracket bolts
(1).
(Tighten: ITM Controller mounting bracket bolts to
60 ± 5 N·m)
6. Remove the ITM Controller assembly.
NOTE :
The ITM Controller assembly is a precision component, be careful to avoid dropping or mis-handling the ITM Con-
troller during removal.
7. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
LTSM160022
LTSM160023
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст