Chery Tiggo. Manual — part 214
Ignition Control System - 2.0L (Page 1 of 1)
GENERAL INFORMATION
LTSMW030037T
03
Ignition Control System - 2.4L (Page 1 of 1)
GENERAL INFORMATION
LTSMW030007T
ON-VEHICLE SERVICE
Ignition Coil 1.6L & 1.8L & 2.0L
Description
The ignition coil consists of primary and secondary groups of wire. The primary wire is located on one end of the coil.
One end of the wire is connected to power and the other end is connected to the Engine Control Module (ECM). The
secondary coil connects two spark plugs. They form a loop and provide high-voltage output.
Operation
When the primary wire is connected to power, current will flow causing a strong magnetic field to form. When the
primary wire is disconnected, the magnetic field will collapse into the secondary wire causing very high voltage out-
put.
Removal & Installation
1. Remove the engine cover.
2. Disconnect the negative battery cable.
3. Disconnect the ignition coil electrical connector.
4. Twist the spark plug wires (1) from the ignition coil
and remove the four spark plug wires.
BESM030028
03
5. Remove the 4 ignition coil retaining bolts (1).
(Tighten: Ignition coil retaining bolts to 6 N·m)
6. Remove the ignition coil.
7. Installation is in the reverse order of removal.
Ignition Coil 2.4L
Description
The ignition coil consists of primary and secondary groups of wire. The primary wire is located on one end of the coil.
One end of the wire is connected to power and the other end is connected to the Engine Control Module (ECM). The
secondary coil connects two spark plugs. They form a loop and provide high-voltage output.
Operation
When the primary wire is connected to power, current will flow causing a strong magnetic field to form. When the
primary wire is disconnected, the magnetic field will collapse into the secondary wire causing very high voltage out-
put.
Removal & Installation
1. Disconnect the negative battery cable.
2. Disconnect the ignition coil connector.
3. Twist the spark plug wire from ignition coils.
4. Remove the ignition coil retaining bolts (2).
(Tighten: Ignition coils retaining bolt to 12 N·m)
5. Remove the ignition coils & spark plug wire assem-
bly (1).
6. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
LTSM080198
LTSM030022
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст