Chery Tiggo. Manual — part 245
Diagnostic Procedure
1.
CHECK A/T SOLENOID SIGNAL
• With the scan tool, select view DTC and data stream for A/T.
• Start the engine.
• Monitor the gear position while driving, and compare to the following table.
TRANSAXLE GEAR POSITION/SOLENOID ACTIVATION
SELECT
POSITION
RANGE
SHIFT
SOLENOID
VALVE 1
SHIFT
SOLENOID
VALVE 2
SHIFT
SOLENOID
VALVE 3
SHIFT
SOLENOID
VALVE 4
P
0
-
-
#
-
R
R
-
-
-
-
N
0
-
-
#
-
D
1
-
-
#
#
2
-
#
-
#
3
-
-
-
-
4
#
#
-
-
• #: Operating component
Is the check result normal?
Yes
>>
The condition that caused this DTC is intermittent (See Diagnostic Help in Section 08 Transaxle &
Transfer Case).
No
>>
Go to the next step.
2.
ACTUATE TEST
• Stop the engine.
• Turn ignition switch on.
• With X-431 scan tool, perform the solenoid actuate test.
• The solenoid actuation should be heard.
Is the check result normal?
Yes
>>
Go to step 5.
No
>>
Go to the next step.
DIAGNOSIS & TESTING
3.
CHECK A/T ASSEMBLY ELECTRICAL CONNECTOR
• Turn ignition switch off.
• Disconnect the A/T assembly electrical connector
E-037 (1).
• Inspect the electrical connector for damage.
Is the electrical connector OK?
Yes
>>
Go to the next step.
No
>>
Repair or replace the electrical connector
as necessary.
4.
CHECK SOLENOID POWER SUPPLY
• Turn ignition switch on.
• Check the solenoid power circuit for battery voltage
between the A/T connector E-037 terminal B3 and
ground.
Is battery voltage present?
Yes
>>
Go to the next step.
No
>>
Repair or replace circuit for an open in
harness or connectors.
DIAGNOSIS & TESTING
LTSMD080023
LTSMD080026
08
5.
CHECK SHIFT SOLENOID VALVE 6 RESISTANCE
• Turn ignition switch off.
• Check the harness continuity between the following terminals:
SOLENOID VALVE 6 RESISTANCE BASED ON TRANSAXLE TEMPERATURE
A/T
ASSEMBLY
TERMINAL
A/T
ASSEMBLY
TERMINAL
TEMPERATURE
CONTINUITY
B3
B2
23°C
Yes
Is the check result normal?
Yes
>>
Go to the next step.
No
>>
Replace solenoid valve 6.
6.
CHECK DTC
• With the X-431 scan tool, read TCM DTCs.
• Refer to ⬙DTC Confirmation Procedure⬙.
Is DTC P0657 still present?
Yes
>>
Replace the TCM.
No
>>
The system is now operating properly.
Reassemble the vehicle and road test to verify the customers complaint is repaired.
DIAGNOSIS & TESTING
P0705 - Multi-Function Switch: Prohibited Position
DIAGNOSIS & TESTING
LTSMW080025T
08
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст