Chery Tiggo. Manual — part 424
Heated Seat Switch
Removal & Installation
1. Using a trim stick, carefully remove the switches (1) from the mounting bezel.
2. Disconnect the heated seat switch electrical connector.
3. Installation is in the reverse order of removal.
Heated Seat Element
Removal & Installation
1. Disconnect the negative battery cable.
2. Remove the appropriate seat cushion.
3. Disconnect the inoperative heated seat cushion electrical connector.
4. Remove the inoperative heating element from the seat.
5. Installation is in the reverse order of removal.
SEATS
LTSM150127
15
IMMOBILIZER CONTROL MODULE
Description
The vehicle security system uses an Immobilizer control module as an anti-theft device that prevents the engine from
starting if an incorrect key is inserted into the ignition switch.
Operation
When an incorrect key is inserted into the ignition switch, the vehicle security system senses the incorrect key and
sends a signal to the Immobilizer control module. The Engine Control Module (ECM) receives the signal from Immo-
bilizer control module via the R-Line. The ECM then disables the engine from starting.
Electrical Schematics
Immobilizer Control Module (Page 1 of 1)
IMMOBILIZER CONTROL MODULE
LTSMW150081T
15
Immobilizer Control Module Connector Pin-Out Table
PIN
CIRCUIT IDENTIFICATION
PIN
CIRCUIT IDENTIFICATION
1
Continuous Supply Voltage
7
Diagnostic Link K
2
GND
8
W-Line
3
-
9
Coil (GND)
4
Ignition Switch
10
Coil (ANT B)
5
R-Line
11
Coil (ANT A)
6
-
—
-
IMMOBILIZER CONTROL MODULE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст