Chery Tiggo. Manual — part 444
Front Combination Lamp Assembly
Removal & Installation
1. Open the hood.
2. Disconnect the turn signal lamp.
3. Disconnect the high/low beam front combination
lamp.
4. Remove the three front combination lamp assem-
bly mounting bolts (1).
5. Carefully remove the front combination lamp assembly.
6. Installation is in the reverse order of removal.
1
Turn Signal Lamp
Bulb
12 V (21 W)
2
Headlamp Bulb
Front Position
Lamp Bulb
12 V (55 W)
12 V (5 W)
EXTERIOR LAMPS
LTSM150037
LTSM150125
15
Headlamp Adjustment Procedure
NOTE :
Follow all local laws and regulations and verify the following items before adjustment:
1. Check the following before starting the headlamp adjustment procedure:
• All tires are filled to the proper tire pressure.
• The vehicle is unloaded (except for spare tire and tools, and include driver’s weight for sedan).
• The vehicle should be parked on a level surface.
• The headlights are clean.
• The headlights are working properly.
2. Park the vehicle on a level surface approximately 10 meters from the vertical wall or screen directly in front of it.
NOTE: The vertical wall or screen must be a minimum of 2.4 meters wide.
3. Use a screwdriver into the two adjustment holes
(1) to adjust the headlamp to proper specifications.
Rear Combination Lamp Assembly
Removal & Installation
1. Open the back cargo door.
2. Remove the lower C-pillar trim (See Lower C-Pillar
Removal & Installation in Section 15 Body &
Accessories).
3. Remove three mounting nuts (1) from the body.
EXTERIOR LAMPS
LTSM150149
LTSM150039
4. Disconnect the rear combination lamp.
5. Carefully remove the rear combination lamp assembly.
6. Installation is in the reverse order of removal.
Headlamp
Removal & Installation
1. Remove the front combination lamp assembly (See Front Combination Lamp Assembly Removal & Installation in
Section 15 Body & Accessories).
2. Remove the headlamp bulb cover.
3. Disconnect the headlamp bulb electrical connector.
4. Remove the headlamp bulb clip.
1
Tail Lamp Bulb
12 V (21 W)
2
Backup Lamp
Bulb
12 V (21 W)
3
Rear Turn Signal
Lamp Bulb
12 V (21 W)
4
Stop Lamp Bulb
12 V (21 W)
EXTERIOR LAMPS
LTSM150126
15
5. Carefully remove the bulb (1) for the high/low
beam headlamp.
6. Replace the bulb with a new bulb as needed.
7. Installation is in the reverse order of removal.
Front Fog Lamp
Removal & Installation
1. Remove the front bumper (See Front Bumper
Removal & Installation in Section 15 Body &
Accessories).
2. Disconnect the fog lamp.
3. Remove three mounting nuts (1).
EXTERIOR LAMPS
LTSM150141
LTSM150038
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст