Chery Tiggo. Manual — part 33
4. Remove the crankshaft timing belt pulley bolt (2)
from the crankshaft.
(Tighten: Crankshaft timing belt pulley bolt to 130
N·m and an additional 65°)
5. Remove the key-way from the crankshaft.
6. Using an appropriate tool, remove the front crank-
shaft oil seal (1).
CAUTION:
Be careful not to damage the front cover seal
surface while removing the seal.
7. Installation is in the reverse order of removal.
Installation Notes:
• Lubricate the new front seal with engine oil prior to assembly.
• Use the front crankshaft seal installer CH-20007
(1), to install the new seal.
Rear Crankshaft Oil Seal
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• CH-20005 - Rear Crankshaft Oil Seal Installer
• CH-20006 - Rear Crankshaft Oil Seal Guide
• CH-20043 - Flywheel Fixture
1. Remove the transaxle assembly (See Transaxle Assembly Removal & Installation in Section 08 Transaxle and
Transfer Case).
2. Using special tool CH-20043 (1), hold the flywheel.
ON-VEHICLE SERVICE
LTSM020199
LTSM020216
LTSM080145
02
3. If equipped with manual transaxle, remove clutch
pressure plate retaining bolts (1) and remove the
clutch pressure plate.
(Tighten: Clutch pressure plate bolts to 25 N·m)
4. If equipped with manual transaxle, remove the fly-
wheel bolts (1) and then remove the flywheel.
(Tighten: Flywheel bolts to 75 N·m)
5. If equipped with automatic transaxle, remove the
drive plate retaining bolts (1) and then remove
drive plate.
(Tighten: Drive plate bolts to 75 N·m)
6. Remove the rear oil seal using a suitable tool.
7. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
BESM080046
BESM020058
BESM020031
Installation Notes:
• When installing seal, lubricate seal guide with clean
engine oil.
• Position the seal over the rear crankshaft seal
guide.
• Use special tool CH-20005 (2) and CH-20006 (1),
to install the rear crankshaft oil seal.
• Ensure that the lip of the seal is facing toward the
crankcase during installation.
ON-VEHICLE SERVICE
LTSM020217
02
Engine Mounts
Removal & Installation - Left Mount
NOTE :
The following special tools are required to perform the repair procedure:
• Engine Hoist
1. Disconnect the negative battery cable.
2. Support the engine with the engine hoist.
3. Remove the air cleaner housing. (See Air Cleaner
Housing Removal & Installation in Section 02
Engine).
4. Remove the engine left mount retaining bolts (2)
and remove the engine left mount bracket bolts (1).
(Tighten: Engine left mount bolts to 70 N·m)
5. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
LTSM020156
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст