Chery Tiggo. Manual — part 124
10.
CHECK DTC
• With the X-431 scan tool, read ECM DTCs.
• See DTC Confirmation Procedure.
Is DTC P1545 still present?
Yes
>>
Replace the ECM.
NOTE : The Immobilizer control module must be matched to the new ECM (See ECM Removal & Instal-
lation in Section 03 Electronic Engine Controls).
No
>>
The system is now operating properly.
Reassemble the vehicle and road test to verify the customers complaint is repaired.
DIAGNOSIS & TESTING
03
P2138 - Pedal Position Sensor Performance
DIAGNOSIS & TESTING
LTSMW030045T
DIAGNOSIS & TESTING
LTSMW030044T
03
Check reference values between ECM terminals and ground under the following conditions:
ECM TERMINAL
NO.
ITEM
CONDITION
DATA (DC
VOLTAGE)
32
Regulated sensor
supply 2
Ignition switch: ON
-
Approximately 5 V
33
Regulated sensor
supply 1
-
Approximately 5 V
16
Accelerator Pedal
Position Sensor 1
(APPS1)
• Engine stopped
• Accelerator pedal:
Fully released
0.72 - 0.74 V
• Engine stopped
• Accelerator pedal:
Fully depressed
3.95 V
40
Accelerator Pedal
Position Sensor 2
(APPS2)
• Engine stopped
• Accelerator pedal:
Fully released
0.36 - 0.37 V
• Engine stopped
• Accelerator pedal:
Fully depressed
1.97 V
35
Sensor (GND)
-
Approximately 0 V
36
Sensor (GND)
-
Approximately 0 V
73
Regulated sensor
supply 1
-
Approximately 5 V
On Board Diagnostic Logic
• Self-diagnosis detection logic.
DTC NO.
DTC DEFINITION
DTC DETECTION
CONDITION
DTC SET
CONDITION
POSSIBLE CAUSE
P2138
Accelerator pedal
position sensor
performance
Ignition switch on or
after engine start
Rationally incorrect
voltage is sent to
ECM compared with
the signals from
APPS1 and APPS2.
• Accelerator pedal
position sensor 1
and 2
• Harness or
connectors
• Electronic throttle
control actuator
(TPS1 and TPS2)
• ECM
DTC Confirmation Procedure:
Before performing the following procedure, confirm that battery voltage is more than 12 V.
• Turn ignition switch off.
• Connect the X-431 scan tool to the Data Link Connector (DLC) - use the most current software available.
• Turn ignition switch on.
• With the scan tool, record and erase stored DTCs in the ECM.
• Start engine then select view DTC and data stream.
• If the DTC is detected, the DTC condition is current. Go to Diagnostic Procedure - Step 1.
• If the DTC is not detected, the DTC condition is intermittent (See Diagnostic Help and Intermittent DTC Trou-
bleshooting in Section 03 Electronic Engine Controls for more information.
NOTE :
While performing electrical diagnosis & testing, always refer to the electrical schematics for specific circuit
and component information.
DIAGNOSIS & TESTING
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст