Chery S11 / Chery QQ. Manual — part 57
Chery QQ Service Manual
7. Interior ceiling light switch
OFF position:Interior ceiling light will not illuminate.
ON position:Interior ceiling light will remain on.
Middle position (door position):Interior ceiling light will illuminate when vehicle
door is opened. Interior ceiling light will still illuminate in 8 seconds after close the
door in order to help passenger seating safely.
8. Luggage compartment illuminating lamp
Luggage compartment illuminating lamp will illuminate when luggage compartment
lid is opened (this lamp is not controlled by ignition switch). Please close the luggage
compartment lid after parking.
You can also make this lamp in close state. In other words, the lamp will not
illuminate when luggage compartment lid is opened. Therefore, you can press the
triggering switch to locking position, when you want turn on this lamp, you only use
your hand to release the switch.
9. Hazard warning flashlight switch
When hazard warning flashlight switch on dashboard is pressed, hazard warning
flashlight will be turned on and all turn signal light will light up simultaneously. After
once more a press, all lights go out at the same time. Hazard warning flashlight may
be operated on matter whether ignition switch is turned on. Apply hazard warning
flashlight to warn other drivers and try to avoid stopping on driveway when an
emergent parking or traffic handicapping is avoidless.
- 42 -
Chery QQ Service Manual
Section 3 Removal and installation of entire vehicle
lighting assembly
Explanation of lighting system
Chery S11series passenger car entire vehicle lighting fitting includes illumination
equipment and light signal equipment. It is used to guarantee the car’s normal running
and safe driving at night or in the fog. It includes: headlight (lower beam and upper
beam), front turning light (including small lamp), front foglight, combination taillight
(including backup lamp, turning light, braking/parking light, small lamp and so on),
license plate lamp, interior ceiling light, luggage compartment lamp and rear foglight.
Headlight apply half enclosed type lighting structure, it is convenient to examine and
repair; use halogen bulb to reduce bulb black and increase illuminating intensity and
extend the useful life of bulb.
Removal and installation of entire vehicle lighting assembly
1. Notice proceeding before removal:
a. Close control switch of corresponding lighting fitting, remove the wire connected to
battery;
b. Please don’t touch the bulb by your hands when replace the bulb, otherwise the
fingerprint on the bulb will be heated and volatilize after light up the bulb, and then it
will deposit on the lens surface, so the reflector will become dim.
2. Removal and installation of headlight
Please calibrate the headlight after remove and
install the headlight every time.
Removal:
——Open the engine compartment hood;
——Pull out the harness plug ;
——Remove front bumper(see front bumper removal);
——Loose three bolts (M6*10) fixed on the headlight cross member;
——remove headlight.
- 43 -
Chery QQ Service Manual
Installation:
light in corresponding position, ensure the bolt fixing hole and the
torque 1.6~2.0 N·m. Drop the
3. Removal and installation of front foglight
ou can raise the car first then remove
.
arness connect plug, take out the front
front bumper
stallation:
—First ensure left and right (left lamp sign“L”,
“R”), then put the foglight into
a. Install head
headlight cross member welding nut are concentric;
b. Locate the headlight by three M6 bolts with the
engine compartment hood, verify and adjust the assembly position of headlight,
headlight should protrude from engine compartment hood a little, you can feel that
there is a radian between them by your hands, then tighten the fastener.
Removal:
If possible, y
form bottom
——
Loose the nut, take out the bolt
—
—Remove h
foglight from the location hole of the
In
—
right lamp sign
installation hole from front, insert two locating pin
into location notch and use bolt and nut to tighten it.
——Connect foglight harness butt joint;
- 44 -
Chery QQ Service Manual
4. Removal and installation of front turn signal lamp
emoval:
f possible.
——
screws the take out the turn signal lamp
e
—First you should distinguish left and right(“L” mark in the left lamp, “R” mark in
th
then put the turn signal lamp into the install hole, at last tighten two
tion tail lamp(include
)
two tapping screw, then pull out the lamp;
——Connect the lamp seat harness;
R
——Raise the vehicle and then remove from the bottom of the vehicle i
Loose two
——Remove the harness connector, then take down the turn signal lamp from th
location hole of the front bumper
Installation:
—
e right lamp ),
tapping screw on the install hole;
——Connect the turn signal lamp harness connector;
5. Removal and installation of combina
parking light/braking light, turn signal lamp, backup light
Removal:
——Open the luggage compartment lid;
——Loose
——Pull down the lamp seat harness.
Installation:
- 45 -
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст