Chery S11 / Chery QQ. Manual — part 41
Chery QQ Service Manual Chassis System
86
Section Three Rear Suspension Frame
Rear Suspension service
I . Rear Suspension parts
1. 7. 12. 15. 21. Screw nuts; 2. Horizontal stabilizing bar; 3. 9. 11. 17. Bolts; 4. Lower supporting
stand; 5. Spiral spring; 6. Spacing block; 8. Dampener; 10. Rear bridge; 13.16. Spiral washer; 14. Left
and right swinging arm; 18.20 Washers; 19 Sleeve
Chery QQ Service Manual Chassis System
85
II. Dampener
Removal
1
、Lift up the car and remove the bolts joining
the dampener with the car bridge.
2
、Remove the joining bolt for the dampener and
the car body.
3
、Remove the dampener assembly.
Steps of installation:
1. Do the installation by referring to the steps of
dismounting.
2. Points of attention:
① In the screw tightening process, the fastening
bolts controlled by torque + corner tightening
submission limits should be replaced after each
action of loosening.
②The screws should be tightened to the specified
torques after the installation.
III. Vertical swinging arm and its
sleeve
Removal
1
、Remove the left and right rear wheels.
2
、 Remove the joining bolt for the vertical
swinging arm and the rear bridge.
Chery QQ Service Manual Chassis System
86
3
、 Remove the bolts fastening the vertical
swinging arm and the car body.
4
、Remove the rear swinging arm.
Steps of installation:
1. Do the installation by referring to the steps
of dismounting.
2. Points of attention:
①In the screw tightening process, the
fastening bolts controlled by torque + corner
tightening submission limits should be
replaced after each action of loosening.
②The screws should be tightened to the specified
torques after the installation.
Inspections
Check to see if the swinging arm is damaged
or deformed; check if there are any cracks or
serious wears on the swinging arm sleeve.
The sequence for the installation procedures
is the opposite to those for removal. Tighten the
related bolts with the specified torques. Attention:
when the front sleeve is installed, the cut slots on
the sleeve should face forward and rearward
IV
、 Removal and installation of the
horizontal
stabilizing rod and rear bridge
Removal
1
、Lift up the car and remove the rear wheels and
the brake drums. Remove the E-shaped ring and
brake soft tube from the rear bridge supporting
frame. Remove the oil inlet pipe of the brake
branch pump. Remove the rear brake base plate
and the manual brake pulling wire. Use a jack lift
to lift the center of the rear bridge.
2
、Removal and installation of the rear bridge
horizontal stabilizing rod
1
)Remove the joining bolt for the horizontal
stabilizing rod and the car body.
Chery QQ Service Manual Chassis System
87
2) Remove the joining bolt for the horizontal
stabilizingrod and t he rear bridge.
3) Remove the dampener and the spiral spring.
4) Remove the rear bridge assembly.
Steps of installation:
1. Do the installation by referring to the steps of
dismounting.
2. Points of attention:
①In the screw tightening process, the fastening
bolts controlled by torque + corner tightening
submission limits should be replaced after each
action of loosening.
② The screws should be tightened to the
specified torques after the installation.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст