Chery Fora (Elara A520). Manual — part 117
CHERY A520 SERVICE MANUAL CHASSIS
55
5.
Dismount the bolts connecting the
steering knuckle and the lower control
arm.
Mounting torque: 110±5Nm
6.
Dismount the two bolts connecting the
steering knuckle and vibration damper.
Mounting torque: 110±5Nm
Assembly sequence:
Assemble the steering knuckle in the
reverse sequence of disassembly.
Precautions:
①
Supplement the brake oil in the
braking
system
and
carry
out
air-release adjustment.
②
Check and regulate toe-in value.
③
Fasten the torque.
IV. DISASSEMBLY AND ASSEMBLY
OF THE ENGINE SIDE MEMBER
Disassembly sequence:
1.
Dismount the two bolts connecting the
side member and vehicle body.
Mounting torque: 100-120 Nm
CHERY A520 SERVICE MANUAL CHASSIS
56
2.
D
ismount the bolts connecting the side
member and vehicle body.
Mounting torque: 100-120 Nm
3.
Dismount the bolts connecting the side
member and engine, and can remove
the engine suspension bolts shown in
the figure for easy disassembly.
Mounting torque: 65±5 Nm
Prevent the side member from dropping
when loosening the bolts.
4.
Dismount the side member.
Assembly sequence:
1.
Assemble the side member according
to the reverse sequence of disassembly.
2.
After assembly, the side member must
be fastened to reach up to specified
torque.
V. DISASSEMBLY AND ASSEMBLY OF
UNDERFRAME
AND
STABILIZER
BAR
Disassembly sequence:
1.
Dismount the clip connecting the
steering column and steering device as
well as the fastening bolt of steering
column.
Mounting torque: 25±3 Nm.
CHERY A520 SERVICE MANUAL CHASSIS
57
2.
Uplift the car, and dismount the
fastening nuts of under-frame and
vehicle body.(the left and right sides
are the same)
Mounting torque: 180±15Nm.
3.
Dismount the bolts connecting the
under-frame and control arm (the left
and right sides are the same).
Mounting torque: 180±15Nm
4.
Dismount the bolts connecting the
stabilizer bar and control arm (the left
and right sides are the same).
Mounting torque: 50±3Nm
5.
Dismount the bolts connecting the
under-frame, control arm and vehicle
body. (the left and right sides are the
same)
Mounting torque: 180±15Nm
CHERY A520 SERVICE MANUAL CHASSIS
58
6.
Dismount the bolts connecting the
under-frame and vehicle body (the left
and right sides are the same).
Mounting torque: 80--90 Nm
7.
Dismount the four bolts connecting the
suspensions and under-frame. But for
easy disassembly and assembly, we
suggest
you
dismount
the
rear
suspension bolts shown in the right
figure.
Mounting torque of the four assembling
bolts: 70±5N.m
Mounting torque of rear suspensions:
60±5N.m
8.
Dismount the under-frame, stabilizer
bar and the assembly of steering device
and tie rod.
Note: If the under-frame is not dismounted,
the stabilizer bar cannot be removed from
the car.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст