Chery Fora (Elara A520). Manual — part 2
Chery Service Manual for A520 Body Dimension and Accessories
5
10. Mixing the bonding agent;
Note: Make sure that the moulding be
installed within the application period of the
bonding agent, and the bonding agent should
be mixed within 5 minutes.
① Clean the glass board and the putty
knife completely with solvent
② Mix 500 grams host crystal with 75
grams hardener completely on a glass
board or similar with a scraper
Figure 159
11. Applying the bonding agent;
① Cut off the pot tip and fill the bonding
agent into the pot
② Place the pot into the sealant gun
③ Apply the bonding agent on the glass as
shown in the figure
Figure 160
12. Installing the glass;
Tip: Make sure that the water resistant piece
adhered to the panel of the body as shown in
the figure
Figure 161
10 mm (0.39 inch)
Bonding agent
Chery Service Manual for A520 Body Dimension and Accessories
6
Note: ①
To install the glass, align the
reference marks on the glass and
the body and then lightly press the
glass into from the edge.
②
Apply the bonding agent on the edges of
the glass with a scraper.
Figure 162
③
Clear the excessive or over flown
bonding agent with a scraper.
④
Clamp the glass until the bonding agent
is harden.
Check for water leakage and repair it:
①
Perform the leakage test after the
hardening period.
②
Seal the leakage part with sealant
Figure 163
13.
Install the upper moulding of the
windshield;
Install the upper moulding on the body and
tap it lightly to fasten it.
Install the outer moulding
Figure 164
2.7 mm (0.11 inch)
Chery Service Manual for A520 Body Dimension and Accessories
7
II.
DISASSEMBLING
AND
INSTALLING
THE
REAR
WINDSHIELD
1.
Lay down the seat back and remove the
coat track;
Figure 165
2.
Remove the lower moulding
Cut off the double face adhesive tape at both
ends of the moulding with a scraper as shown
in the figure;
Tip: Entangle the tip of the scraper with
adhesive tape before starts.
Figure 166
3.
Remove the glass of the rear window
①
Pull the piano wire through between the
body and the glass from inside of the
vehicle
②
Tie both ends of the piano wire with
wood block or similar
Tip: Use adhesive tape on the outside to
prevent the external surface from being
scuffed.
Figure 167
Chery Service Manual for A520 Body Dimension and Accessories
8
③
Pull the piano wire along the bonding
agent to cut it off.
Tip: Do not let the piano wire spoil the two
stoppers.
④
Remove the glass, and then remove the
moulding of the rear window
The installing steps are reverse to those for
removal.
Figure 168
INSTALLING THE GLASS OF THE
REAR WINDOW
1.
Fitting the rear window moulding
Place the moulding around the glass and fit it
manually.
Tip: Be sure to remove the glass of the rear
window first before fitting the moulding
Figure 169
2.
Clean and finish the contact surface of
the body and cut off the rough parts on
the body;
Tip: Leave bonding agent as much as
possible on the body and clean the cut
surface of the bonding agent with a rag
soaked with washer fluid.
Tip: Even if the entire bonding agent has
been cleared, you should also clean the body.
Figure 170
Stopper
Bonding
agent
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст